32cc/1.9 cu.in. 2-Cycle GASOLINE WEEDWACKER ® Model No. 358.791072 • Safety • • • Assembly Operation Maintenance • Parts List • Eapa_ol, p. 23 WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers Call 7 am-7 to your questions about this product: pm, Mon.-Sat., or 10 am-7 pm, Sun. 1-800-235-5878 Sears, Roebuck 545167680 _Hou,s listed are Central and Co., Hoffman Rev. 5 7/16/08 BRW Estates, ]qme) IL 60179 U.S.A.
Warranty Statement Identification of Safety Symbols Safety Rules Assembly Operation Maintenance 2 2 4 10 11 15 Storage Troubleshooting Table Emissions Statement 17 18 19 Parts List Spanish 2t 23 Service & Adjustments 16 Parts and Ordering ONE YEAR FULL WARRANTY ON CRAFTSMAN Back Cover GAS WEEDWACKER When used and maintained according to the operator's manual, if this product fails due to a defect in material or workmanship within one year from the date of purchase, return it to any Seals store,
Hazard zone forthrown objects. • Trimmer linethrows objects violently< • Youandothers canbeblinded/injured. • Keep children, bystanders, andanimals 50feet(15meters) away. f _ | ..._li •_ _[I _O _lllll_ Ill • I Do not wear jewelry, loose clothing, I I or clothing with loosing hanging IISecure straps, ties, etc< Theylength. can hair tassels, above shoulder J be caught in moving parts< Assist handle to be positioned the arrow.
I_1 ratio of 40:1 (2<5%). se unleaded gasoline and two-stroke oit mixed at a These attachments used in combination with the specified powerhead have been evaluated to ANSI B175.3-2003, "Grass Trimmers and Brushcutters - Safety Requirements". These combinations have been evaluated by Underwriter's Laboratories Inc. (UL) and are consequently UL listed: Powerhead Brushcutter including trimmer attachment ...................... attachment ......................................
• Being fullycovered alsohelps protectyoufromdebris andpieces of toxicplants thrown byspinning line. • StayAlert. Donotoperate thisunit when youaretired,ill,upset orundertheinfluence ofalcohol, drugs, ormedication. Watch whatyouare doing; usecommon sense. • Wear hearing protection. • Never start or run inside a closed room or building. Breathing exhaust fumes can kill. • Keep handles free of oil and fuel. • Always keep engine on the right hand side of your body. • Hold the unit firmly with both hands.
theavoidance ofthese problems. Userswhooperate power toolsonacontinual andregular basis must monitor closely theirphysical condition andthe condition ofthistool. SPECIAL NOTICE: Thisunitis equipped withatemperature limiting muffter andspark arresting screen which meets therequirements ofCalifornia Codes 4442and4443.AllU.S. EDGER SAFETY forest landandthestates ofCalifornia,A_)&WARNING: Inspect the area to Idaho, Maine, Minnesota, NewJersey, be edged before each use.
• Never place objects inside theblowertubes, vacuum tubes orblower outlet. Always direct theblowing debrisaway frompeople, animals, glass, andsolidobjects suchas trees, automobiles, wails, etc.The forceofaircancause rocks, dirt,or sticks tobethrown ortoricochet which canhurtpeople oranimals, break glass, orcause other damage. • Never rununitwithout theproper _ WARNING: Inspect the area to equipment attached. When using cut before each use.
• Avoid heavy contact withsolid objects thatmight stopthetines. Ifheavy contactoccurs, stoptheengine andinspect theunitfordamage. • Never operate thecultivator without the tine cover inplace a nd properly secured. • Keep thetinesandguard clear of debris. • Afterstriking aforeign object, stop theengine, disconnect thespark plugandinspect thecultivator for damage. Repair before restarting. • Disconnect attachment fromthedrive engine before cleaning thetines with ahose andwater torernove any build-up.
• Always stoptheunitwhen workis delayed orwhenwalking fromone cutting location toanother. • Ifyoustrike orbecome entangled withaforeign object, stoptheengine immediately andcheck fordamage. Have anydamage repaired bya Sears Sewice Center before attempting further operations. Discard blades thatarebent,warped, cracked orbroken. • Stoptheunitimmediately ifyoufeel excessive vibration. Vibration isa signoftrouble. Inspect thoroughly forloose nuts,bolts ordamage before continuing.
CARTON CONTENTS Check carton contents against thefollowing list. Model 358.791072 5. 6. Powerhead Trimmer attachment Shield Wing Nut (screwed onto shield) Container of line Container of oil Examine parts for damage. Do not use damaged parts. NOTE: If you need assistance or find parts missing or damaged, call 1-800-235-5878. It is normal for the fuel filter to rattle in the empty fuel tank. Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
ADJUSTING THE HANDLE _WARNING: When adjusting the assist handle, be sure it remains above the safety label and below the mark or arrow on the shaft. 1. 2. / Shield Gearbox Loosen wing nut on handle. Rotate tlle handle on the shaft to an upright position; retighten wing nut. KNOW YOUR TRIMMER READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT Compare file illustrations with your unit to familiarize yourself with the location of file various controls and adjustments.
engine oil.Werecommend Craftsman STARTING A COLD ENGINE brand synthetic oil.Mixgasoline andoil NOTE: DO NOT squeeze the throttle ataratio of40:1. A40:tratio isobuntil the engine has started and tained bymixing 3.2ounces ofoilwith1 trigger runs. gallon ofunleaded gasoJine. Included 1. Set unit on a flat surface. withthistrimmer isa3.2ounce contain- 2. Slowly press the primer bulb 6 elofoil.Pour theentire contents ofthis times. container into1gallon ofgasoline to 3.
CRAFTSMAN ® CONVERTIBLE FEATURE TM This model is equipped with a coupler which enables optional attachments to be installed. The optional attachments C°uple_eide Recess are: Edger ................. Cultivator .............. Blower ................ Brushcutter ............ Pruner ................ 358.79240 358.79241 358.79242 358.79244 358.79245 _WARNING: Always stop unit and disconnect spark plug before removing or installing attachments.
When operating unit,stand asshown andcheck forthefollowing: • Wear eyeprotection, hearing protectionandheavy clothing. • Hold trigger handle withrighthand andassist handle withlefthand. • Holdunitsothatengine isbelow waist level. • Cutonlyfromyourlefttoyourright to ensure debris istilrown away from you.Without bending over, keep tine near andparallel totheground and notcrowded intomaterial being cut. Donotruntheengine atahigher speed thannecessary.
SWEEPING - The fanning action of the rotating line can be used to blow away toose debris from an area. Keep the tine parallel to and above the area surface and swing the tool from side to side. MAINTENANCE SCHEDULE WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments.
As your unit is used, carbon deposits build up on the muffler and spark arresting screen. For normal homeowner use, however, the muffler and spark arresting screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your Sears Service Center. REPLACE SPARK PLUG Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Ignition timing is fixed and nonadjustable. 1.
2. Insert asmall screwdriver into aligned holes, Thiswillkeepthe shaft fromturning whileremoving andinstalling trimmer head. Screwdriver Arbor shaft 3. While holding thescrewdriver in position, remove trimmer headby turning clockwise. 4. Thread replacement trimmer head onto fileshaft byturning counterclockwise. Onlytighten handtight! 5. Remove thescrewdriver. CARBURETOR ADJUSTMENT _WARNING: Keep others away when making idle speed adjustments. The trimmer head witt be spinning during most of this procedure.
Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuet tank or fuel storage container. Follow the mix instructions found on stabilizer container. Run engine at least 3 minutes after adding stabilizer. Craftsman 40:1,2-cycle engine oil (air cooled) is already blended with fuel stabilizer. If you do not use this Sears oit, you can add a fuet stabilizer to your fuel tank.
YOUR WARRANTY RIGHTS AND OBLIGATIONS: The U.S. Environmental Protection Agency/California Air Resources Board and Sears, Roebuck and Co., U.S.A., are pleased to explain the emissions control system warranty on your year 2007 and later small offroad engine. In Califomia, all small offroad engines must be designed, built, and equipped to meet the State's stringent anti-smog standards.
MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RELATED PARTS: Any Sears approved replacement part used in the performance of any warranty maintenance or repair on emission related parts will be provided without charge to the owner if the part is under warranty. EMISSION CONTROL WARRANTY PARTS LIST: Carburetor, Ignition System: Spark Plug (covered up to maintenance schedule), Ignition Module, Muffler including catalyst, Fuel Tank (California only).
REPAIR PARTS SEARS TRIMMER MODEL 358.791072 27 24 Ref. Part No.
REPAIR PARTS _ WARNING SEARS TRIMMER MODEL 358.791072 All repairs adiustments al]d mainte_ance _ot deseribed in tl_e Operator's Manua_ mu3t be periormed by qualified service personnel¸ 2 9 23 i 10 24 3 11"12 13 1:4 i 15 22 18 40 i 48 43 I i 65 Ref. 2 3 4 5 6 7 8 9 10 11 12 13 E 14 15 16 17 18 19 20 21 22 23 Part No.
