Manual

ASSEMBLY
(If tool is reeeivM, assembled, repeat all steps in this section to be.sure assembly is correct and ii ad-
justed for the operator.)
A. PREPARATION
' This Manual is designed to help you _semble the tool
and to provide its safe operation. It is important that
you read the entire manual to become familiar with
the tool before you begin a_sembly. If you have ar_v
questions or need fixrther assistance, car our
CUSTOMER ASSISTANCE HOTLINE at
!-800-235-5878.
_1] ]1 I II IIIIIII I I I/ __ , HI I Illllllllllllll Jill
z. ltead yotw Operator's _
2. Toeh you willaee&
- Hex Wrench ¢avvided with the tool.
_j__ • Wx_.n_orta_ plien
Flat Blade Screwdriver
B.ASSEMBLY ST_PS
Hardware referredtoin.thefollowings_."oneisshown actualsizeintheHardware Chart,page5.
i.Tt_E
v. Place the two screws _L" into the holes on t_e
b. Posltionthe]ock-nutb"E." in the lower holes.
c. Tighten ,scr_-,vswith the-small hex wrench (.pro-
vided) just enoug h to hold hardware together
while homing lock-nuts .with your other hand.
d. Remove the packingcoverfrom the.straight
end of the tube(ifsoequipped). Your unit may
not have a packing cover.
not fall out of the tube_ Dirt on the shaft will sig-
nificantly reduce the life of the unit. If the flex_e
ddve shaft falls out of the housing, clea_ re-]u_
hricate, andi,_-re install See _Flexible Drive Shaft
Lubrication" in the Maintenance section.
e. _the bot_m 8r6o_ ozi"the tube With the
ridge on the lower wall ofthe engine opening.
£ Turn the shafttoalignthe'squvxeend of the
shaft wifllthe sqaure hole insidethe front
opening of the engine,
g.ra_...y_ thence_to theen_ o_..a_.
untll t_e _ ff_d conta_ or _ wRhm
3mm (!/8") ofthe, dutch:_using.
h. Tighten screws "A.". alternately with the hex
wrench until secure.
Shaft
• L....... ' ........ ' "!'2"2
.......... .-- .:_ _
6