Owner's Manual

10
APPLICATIONS
Air compressors are utilized in a variety of air system applications.
Match hoses, connectors, air tools, and accessories to the
capabilities of the air compressor.
You may use this tool for purposes listed below:
Operating air powered tools requiring less than
2.8 SCFM @ 90 PSI or 3.5 SCFM @ 40 PSI.
Powering pneumatic nail guns, inating tires, cleaning /
blowing with pressurized air.
HOWTOUSEYOURAIRCOMPRESSOR
See gures 7 - 8.
Do not allow familiarity with tools to make
you careless. Remember that a careless fraction of a second
is sufcient to inict serious injury.
Always wear safety goggles or safety
glasses with side shields when operating power tools. Failure
WARNING
WARNING
Always ensure the switch is in the OFF(O)
position and the regulator pressure gauge reads zero before
changing air tools or disconnecting the hose from the air outlet.
Failure to do so could result in possible serious personal injury.
Connect the power cord to the power supply.
Turn the ON/OFF switch to the ON(I) position.
Rotate the pressure regulator knob to the desired line
pressure. Turning the knob clockwise increases air pressure
at the outlet; turning the knob counterclockwise reduces air
pressure at the outlet.
NOTE: Before connecting or disconnecting air tools, turn the
regulator knob counterclockwise to stop the ow of air.
Following all safety precautions in this manual and the
manufacturer’s instructions in the air tool manual. You may
now use your air-powered tool.
WARNING
Fig. 8
Coilhosewithquick
coupler attached
Male connector
fitting
Pneumatic
tool
If not already installed, attach the hose to the compressor.
Connect the air powered tools to the air hose by inserting the
male quick-connect plug to the quick-coupler at the end of the
hose (see g. 8).
On/Off
switch
Fig. 7
Drainvalves
Pressure
regulator knob
TRANSPORTANDLIFTING
Transport
See gure 5.
Pull the telescopic handle (see g. 5) out until it locks into
place.
NOTE: This handle is only for pulling the unit. DO NOT lift the
unit by this handle.
To lower handle push it down.
Lifting
See gure 6.
For lifting the unit use only the red carry handle (see g. 6).
to do so could result in objects being thrown into your eyes
resulting in possible serious injury.
Do not use in an environment that is dusty or
otherwise contaminated. Using the air compressor in this type
of environment may cause damage to the unit.
Ensure the tank drain valves are closed (see g. 7).
Ensure the ON/OFF switch is in the OFF(O) position and the
air compressor is unplugged (see g. 7).
Ensure the pressure regulator knob is turned fully
counterclockwise (see g. 7).
CAUTION
Fig. 6
Fig. 5