Owner's Manual

ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2) 1/2" Wrenches
STEP 1: (SEE FIGURE 1)
• Secure each bag arm channel (6) to the sweeper
housing using two 3/8" x 2-1/4" clevis pins (23) and
two small hairpin cotters (19).
STEP 2: (SEE FIGURE 2)
• Place a pivot rod support bracket (28) in the end of a
bag arm channel and then insert a pivot rod retainer
(26) down into the slots in the bracket and the
channel. Repeat for the other bag arm channel.
FIGURE 1
FIGURE 2
23
19
6
STEP 3: (SEE FIGURE 3)
• Install a compression spring (27) into the bottom of
each of the pivot rod retainers, securing them to the
bag arm channels.
FIGURE 3
28
26
1
2
27
21
4
3
59
59
15
4
16
19
FIGURE 4
STEP 4: (SEE FIGURE 4)
• Attach the drawbar brackets (4) to the drawbar (3)
using one 5/16" x 2-1/2" hex bolt (15), two washers
(59), and one 5/16" nylock nut (21). Make the nut
ngertightonly.
• Insert the 3/8" x 3" pin (16) into the brackets and
drawbar and install a small hairpin cotter (19).
5