Owner's Manual

FIGURE 5

STEP 5: (SEE FIGURE 5)

• Attach the drawbar and brackets to the sweeper

using two 5/16" x 2-12" hex bolts (15) and two 5/16"

nylock nuts (21). Tighten all three bolts installed in the

brackets, then loosen the front bolt by 1/4 to 1/2 turn.

STEP 6: (SEE FIGURE 6)

• Measure the distance from the tractor hitch to

the ground. Arrange the hitch brackets as shown

according to your tractor's hitch height.

• Attach the bent hitch bracket (2) and straight hitch

bracket (1) to the drawbar using two 5/16" x 2-1/2" hex

bolts (15) and 5/16" nylock nuts (21).

• Assemble the hitch pin (60) and two 3/4" spacers

(22) to the hitch brackets. Secure them in place with a

large hairpin cotter (18).

STEP 7: (SEE FIGURE 7)

• Install a rear hopper tube (9) onto the ends of the two

lower hopper tubes (7). Secure them with two 1/4 x

1.11" clevis pins (25) and small hairpin cotters (19).

FIGURE 8

STEP 8: (SEE FIGURE 8)

• Install a rear hopper tube (9) onto the ends of the two

upper hopper tubes (8). Secure them with two 1/4 x

1.11" clevis pins (25) and small hairpin cotters (19).

FIGURE 7

holes point down

HITCH HEIGHT

11" TO 13"

HITCH HEIGHT

7" TO 9"

HITCH HEIGHT

9" TO 11"

FIGURE 6