Manual

STEP3: (SEE FIGURE 4)
• Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for second
plug.
STEP 4: (SEE FIGURE 5)
• Remove any bolts present in front mounting holes in
side of tractor frame. If bolt will not screw out of hole,
check if a nut is present on bolt on inside of frame.
On GT tractors, if access to nut is blocked by a front
mounted muffler, slide muffler down exhaust tubes to
rest on top of browning shield.
IMPORTANT: Be sure to re-attach muffler and heat
shield after bumper is installed.
* If rear mounting holes in tractor frame are empty,
install hex bolts and whiziock nuts supplied in the
parts bags. See figure 5.
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE