Operating instructions

iNSTRUCTiONS FOR ALL TRACTORS

STEP 25: MOUNT SCOOP TO TRACTOR

(SEE FIGURE 24)

, Align the scoop with the side plates on the front of the

tractor, Lift the rear of the scoop and slide the notches

in the scoop frame onto the bolts or pins in the tractor

side plates, Stand on the left side of the tractor and

push down on the scoop dump handle until the holes

in the scoop frame and the holes in the side plates are

aligned, Insta!l the attachment rod through the holes

from the left side and secure it with a long hairpin

cotter (FF),

LONG

HAURPIN

COTTER (FF)

DUMP HANDLE

BOLT OR PmN

FIGURE 24

STEP 2{}: ADJUSTTILT BRACKET ASSEMBLY

(SEE FIGURE 25)

, Lower the scoop assembly onto a smooth level

surface, For norma! use, let the bottom of the bucket

rest fiat on the ground, For more aggressive scraping

action, place 1/4" shims under the rear of the bucket

at each end,

Swing the tilt bracket forward to check for clearance

with the pin stop bracket. There should be a small

gap between the tilt bracket and the side of the pin

stop bracket. If not, adjust the position of the pin stop

bracket side to side.

Make sure the two bolts in the tilt bracket are loose

enough to turn by hand. Align the tilt bracket so that

the dump control pin snaps into the hole in the tilt

bracket. The tapered end of the pin should extend

clear through the tilt bracket. Tighten the two bolts

and nuts in the tilt bracket.

TIGHTEN

TiLT BRACKET

PIN STOP BRACKET

FIGURE 25