Manual

WHEEL GEARS/PAWL SERVICE
1, To service wheel gears, Do Not Remove both
wheels at the same time. Remove one wheel
at a time to prevent use of left hand parts on
right hand side, When removing gears make
notes on position of all washers and snap rings,
2, The paw!, inside ratchet gear, has a curved end
(side) and a flat end (side), See figure 32_ When
re-assembling ratchet gear and pawl, fill the
inside with grease. Re-assemble the wheel and
turn wheel, if the brushes drive (rotate) in both
directions, the pawi is assembled incorrectly,
remove and flip pawl over, If the brushes drive
(rotate) in one direction the pawl is assembled
correctly.
BRUSH
1.
2.
REPLACEMENT
Remove the hopper bag from lawnsweeper
Brush replacement should be done one
brush at a time,
3, Tip the sweeper back on housing for ease of
brush replacement° Do not remove hex bolts
from double brush retainers through brush
shaft.
4., Loosen hex bolts and hex lock nuts from single
brush retainers, See figure 33. Slide brush out
of retainers making note of over-lap bristles
position.
5 Install new brush, maldng sure over-lap bristles
are positioned the same as before and as shown
in figure 33 (end view of brush),
RATCHET
GEAR
PAWL
FIGURE 32
BRUSH
RIGHT END VIEW
ROTATION
OF BRUSH -------_.__.!
DOUBLE
BRUSH
RETAINER
OIL BEARING HERE
OVERLAP _
BRISTLES
OVER-LAP
BRISTLES
SINGLE
BRUSH
RETAINER
_'_BRUSH
SHAFT
SINGLE
BRUSH
RETAINER
BRUSH
ROTATION
FIGURE 33
12