Manual

6_
7_
Place assembled lower hopper tubes into
bottom of hopper bag, See figure !4.
Assemble the upper and lower hopper tube
ends together with two 318" x 3/4" hex bolts
(inside} and 3t8" hex lock nuts (outside), See
figure 14. Do not overtighten to allow for pivot,
UPPER HOPPER TUBE
3/8" HEX LOCK NUT
(OUTSIDE)
HOPPER
"- TUBE
84 Assemble the bag frame strap (bottom) and bag
retainer (top) to the front edge of bag bottom_
Place the bag retainer on top and frame strap
on bottom. Secure with four #10 x 5/8" slotted
screws and #t0-32 hex lock nuts., See figure 15.
10, Secure the bag corners over lower hopper tube
by snapping the flap to bag bottom on each side,
See figure t7.
;NAPS
FLAP
FIGURE 17
Assemble the two hopper support rods as
shown in figures 18 and 19, Place top end of rod
into hole in upper tube and bend rod outwards
and snap bottom end of rod into hole in bottom
tube, NOTE: Rods are spring steel and require
bending or bowing as shown° Do not over bend
and lose bag support tension.
PRONT EDGE OF BAG
#10 x 518" SCREW
BOTTOM
'IsTRA p
_;_#10-32 HEX
LOCK NUT
FIGURE 15
9 Assemble the frame strap to the lower hopper
frame Secure with 1/4" x 1q/4" hex bolts and
1/4" lock nuts. See figure 16.
LOWER HOPPER FRAME
1t4"
(INSIDE)
FIGURE 16
114" × 1-tt4" HEX BOLT
(0 UTSIDE)
FRAME STRAP
7
IPPORT ROD
FIGURE 18
FIGURE 19
SUPPORT RODS