Specifications

SERVICE AND ADJUSTMENTS
TO REMOVE HOOD (See FIGS. 38 and 39)
• Reach under front of hood and disconnect hood latch
spring,
• Raise hood.
e Disconnect headlight wire harness
• Remove screw used to attach hood lanyard to front of
engine+ Hotd hoodsecurely to prevent hood fromfalling
e Remove hairpins and clevis pins used to attach hood to
mountingbrackets+
e To reinstall, reverse above procedure.
HOOD
,LATCH
SPRING
HEADLIGHT MOUNTING
WIRE HARNESS BRACKET
A
FIG. 38
HOOD
LANYARD
CLEVIS
VIEW FROM RIGHI" SIDE OF TRACTOR
FIG+39
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See FIG. 40)
The throttle control has been preset at factory and adjustment
should not be necessary if adjustment is necessary, proceed
as +otlows:
e With engine not running, move throttle control lever to
FAST positionor detent postion
• Loosen clamp screw so throttle cable can be moved Jn
cable clamp. (Do not remove cable clamp trom control
bracket or disconnect remote control cable from controt
lever,)
• Move control lever to FAST position and hold in this posi-
tion,.
• Tighten clamp screw securely so cable clamp wili hotd re+
mote control cable in place when remote equipment is
used,
The engine controls should now be adjusted corretly
CONTROL LEVER - IN '*FAST"
POBMON ,HOLE IN LEVER
\
FIG,. 40
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and adjustment
should not be necessary However ifyou think your carburetor
needs adjusting see your nearest SEARS SERVtCE
CENTER.
32
,
!