Operator`s manual

[o_o)_l
,_ WARNING: The starter i8
equipped with a three-wire
power cord and plug and is
designed to operate on 120 volt AC
household current. It must be prop-
erly grounded at all times to avoid
the possibility of electrical shock
which may be injurious to operator.
• Follow all instructions carefully
as set forth in the "To Start En-
gine" section.
• Determine that your house wiring
is a three-wire grounded system.
Ask a licensed electrician if you
are not sure. If your house wire
system is not a three-wire system,
do not use this electric starter un-
der any conditions.
If your system is grounded and a
three-hole receptacle is not avail-
able at the point your starter will
normally be used, one should be
installed by a licensed electrician.
When connecting 120 volt AC
"Power Cord", always connect the
cord to the Switch Box on the en-
gine first, then plug the other end
into the three-hole grounded re-
ceptacle. When disconnecting
"Power Cord", always unplug the
end in the three-hole grounded re-
ceptacle first.
How To Start A Cold Engine
1. Make sure auger drive lever is in
the disengaged (RELEASED) posi-
tion.
2. Move the choke control to the
START position (see Figure 9).
Figure 9
3. (Electric Start) Plug the power cord
into the starter motor on the en-
gine. Plug the other end of power
cord into a three-hole, grounded
120 VOLT, AC receptacle.
4. Push the primer button as speci-
fied below. Remove finger from
primer button between pushes (see
Figure 10).
• Push two times if temperature is
15° F (-9 ° C) or higher.
• Push four times if temperature is
below 15° F (-9 ° C).
F 041032C
12
Primer
Button •
Figure 10
(Electric Start) Turn the key to the
START position (see Figure 11). To
prolong the life of the starter, do not
crank for more than 5 seconds at a
time. Wait one minute between
starts to allow the starter motor to
cool.
Figure 11