Operator`s manual

How To Assemble The Handle
1.
2.
3.
Remove the T-knobs and U-bolts
(Figure 1).
Put the upper handle in the opera-
tor's position.
Install the U-bolts and tighten the
T-knobs.
Note: Make sure that the cable is
not pinched between the upper
and lower handle. Make sure the
cable is routed as shown in
Figure 2.
4.
5.
Attach the auger drive cable to the
auger drive lever (Figure 1).
Remove the T-knob and bolt on the
upper chute and rotate the upper
chute to the operating position
(Figure 3).
Install the bolt and tighten the
T-knob.
\
Upper
Handle
Cable
igure 2
Upper Chute
_Knob
Figure 3
_" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
All assembly instructions have been
completed.
_" The discharge chute rotates freely.
No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_' Make sure engine oil is at proper lev-
el. Use a high quality detergent oil
classified "For Service SG, SH, S J,
SL, or higher".
_' Make sure the fuel tank is filled prop-
erly with clean, fresh, unleaded gaso-
line with a minimum of 85 octane.
_' Become familiar with the location of
all controls and understand their
function.
_' Before starting the engine, make sure
all controls operate correctly.
F 041032C 7