Operating instructions

3. Twistingnozzleadjustsspraypatternfromafanpattern
toanarrowpattern.
UsageTips
• Formost effective cleaning, keep spray nozzlefrom 8 to
24 inches away from cleaning surface.
• If you get spray nozzletoo close, especially using high
pressure mode,you may damage surface being cleaned.
• DONOTget closer than 6 inches when cleaning tires.
Using the Turbo Hozzle
The turbo nozzlespins a 0° nozzlestream in a circular
pattern, providing an intense wide-spray pattern for scouring
large surface areas fast and efficient.
A turbo nozzlecan easily cut through heavyoil and grease
stains on concrete, brick and plastic and strip paint from
various surfaces. DO NOTuse the turbo nozzleon delicate
materials,especially wood. Always start the turbo nozzleat a
distance, gradually getting closer to the surface until you get
the cleaning force you want. Always keepthe turbo nozzlein
a constant motion. NEVERdwell on a single spot. Passover
stubborn stains repeatedlyuntil they are gone using even
strokes.
I wAR.I.G
Always make sure the surface you will cleanwill not be
damaged by the high pressure spray by testing in a hidden area.
Toattachtheturbonozzleto the spraygun:
1. Engagetrigger lock on spray gun trigger.
2. Remove nozzleextension from spray gun, if attached.
3. Attach turbo nozzleextensionto spray gun. Tighten by
hand.
4. Disengagetrigger lock on spray gun trigger.
5. For most effective cleaning, keep turbo nozzlefrom 8 to
24 inchesaway from cleaningsurface. If you get turbo
nozzletoo close, you may damagecleaning surface.
NOTE:Detergentcannot be applied with turbo nozzle.
Applying Detergent with Adjustable Nozzle
A CnUTlOe
UseONLYpressurewashersafedetergents/soaps.
To apply detergent, fellow these steps:
1. Review use of adjustable nozzle.
2. Preparedetergent solution as required by job.
3. Placefilter end of detergentsiphoning tube into
detergentcontainer.
NOTE:Makesure the filter is fully submerged in detergent
while applying detergent.
NOTICE
j Wheninsertingthe filterinto a detergentsolutionbottle,route
tube so asto keepit frominadvertentlycontactinghot muffler.
4. Slideadjustable nozzleforward to low pressure mode.
Detergentcannot be applied with nozzlein high pressure
position.
5. Makesure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE
Starting the engine without all the hoses connected and without
the water turned ONwill damage the pump.
Damageto equipment resulting from failure to follow this
instruction will void warranty.
13