Operating instructions

6. Engagetrigger lock on spray gun and start engine
following instructions "How to Start Your Pressure
Washer".
7. Apply detergentto a dry surface, starting at lower
portion of area to be washedand work upward, using
long, even, overlapping strokes.
8. Allow detergentto "soak in" for 3-5 minutes before
washing and rinsing. Reapplyas neededto prevent
surface from drying. DO NOTallow detergentto dry on
(prevents streaking).
IMPORTANT:You must flush the detergent siphoning system
after each use by placing the filter into a bucket of clean
water, then run the pressure washer in low pressure for
1-2 minutes.
Pressure Washer Rinsing
FerRinsing:
1. Slide nozzlebackward to high pressure, press trigger
and wait for detergentto clear.
NOTE:You can also stop detergentflow by removing
detergent siphoning tube from container.
2. Keepspray gun a safe distance from areayou plan to
spray.
WARNING
Operatepressurewasherfrom astablesurface.
Beextremelycarefulif youmust usethe pressurewasherfrom
a ladder,scaffoldingorany othersimilarlocation.
Firmlygraspspraygunwith bothhandswhenusinghigh
pressuresprayto avoidinjury whengunkicksback.
3. Apply a high pressure spray to a small area, then check
surface for damage.If no damage is found, it is okay to
continue cleaning.
4. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for washing and
applying detergent.
Cleaning Detergent Siphoning Tube
If you used the detergentsiphoning tube, you must flush it
with clean water before stopping the engine.
1. Placedetergent siphoning tube/filter ina bucket full of
clean water.
2. Engagetrigger lock on spray gun.
3. Slideadjustable nozzleforward to low pressure position.
4. Flushfor 1-2 minutes.
5. Shut off engine following instructions "How to Stop
PressureWasher" and turn off water supply.
A WARNING
Keep high pressure hose connectedto pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction and squeezespray gun
trigger, to releasehigh pressure, every time you stop engine.
Engagetrigger lock when not in use.
6. ALWAYS point gun in a safe direction and squeezespray
gun trigger to releaseretained high water pressure.
iMPORTANT:Spraygun traps high water pressure,evenwhen
engineis stoppedand water is disconnected.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F (51°C). The system engages to cool the pump by
dischargingthewarm water ontothe ground.
14