Operating instructions

Your pressure washer requires some assembly and is ready
for use only after it has been properly servicedwith the
recommended oil and fuel.
If you haveany problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
IMPORTANT:Any attempt to run the engine before it has
been serviced with the recommended oil will result in an
engine failure.
Attach Handle
1. Placeplastic adapters in hinges on handleextension as
shown.
Unpack the Pressure Washer
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents. If any parts are missing or damaged,call
the pressurewasherhelplineat 1-800-222-3136.
* The main unit
* Handle
* High pressure hose
* Spray gun
* Nozzleextension with adjustable nozzle
* Turbo nozzle
* Wheel kit
* Engineoil
* Parts bag (which includes items listed below)
Operator's manual
Safety goggles
Becomefamiliar with each piece before assembling the
pressure washer. Comparecontents against the view on page
6. if any parts are missing or damaged,call the pressure
washer helpline at 1-800-222-3136.
ASSEMBLINGYOURPRESSUREWASHER
Your Craftsman pressure washer was mostly assembledat
the factory. However,you wiil needto perform these tasks
before you can operateyour pressure washer:
1. Attach handleto main unit.
2. Install wheel kit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connecthigh pressurehoseto spraygun and pump.
6. Connect water supply to pump.
NOTE:Make sure lip on plastic adapters is facing up in
hinges.
2. Clamp handleextension onto pressure washer handle
and insert T-bolts into holes of clamp. Tighten by hand.
Install Wheel Kit
The wheel kit is designedto greatly improve the portability of
your pressure washer.
NOTE:Wheel kit is not intended for over-the-road use.
installthewheelkit asfollows:
1. Placethe bottom of the pressurewasherframe ona flat,
evensurface,such as blocksto easeassembly.
2. Spread axle brackets apart and place over front vibration
mounts on the pressure washer frame as shown.
\
\
\
Squeezeaxle brackets back to original shape.
\