Operator`s manual

Yourpressurewasherrequiressomeassemblyandisready
foruseonlyafterithasbeenproperlyservicedwiththe
recommendedoilandfuek
_fyouhave any problemswith the assembly of yeur
pressurewasher, pJeasecaJJth8 pressurewasher heJpJiNe
at 1-800-222-3136.
UNPACKTHEPRESSUREWASHER
1. Remove everything from carton except pressurewasher.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents, if any parts are missing or damaged,call
the pressure washer helplineat 1o800o222o3136.
* Main Unit
* Handle
* Accessory Tray with HoseWrap
* High PressureHose
* Spray Gun
* Nozzle Extensionwith Quick Connect Fitting
* Oil Bottle
* Bottle Bracket Wireform
* PerfectMixTM Siphoning Unit/Hose
* Parts Bag(which includes the following/:
* Operator's Manual
* Owner's Registration Card
* Rubber Straps (2)
* Bagcontaining 3 Multi-Colored Quick Connect Spray
Tips
* Handle FasteningHardware Kit twhich includes}:
* Handle Bolts (2)
° CarriageBolt (1)
, Plastic Knobs for Handle(21
, Plastic Knob (1)
, Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1o800o222o3136
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will needassembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessorytray.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supplyto pump.
7. Attach nozzleextension to spray gun.
8. Select/attach quick connect spraytip to nozzleextension.
Attach Handteand Accessory Tray
1. Place handle(A) onto handle supports connected to
main uniL Make sure holes in handlealign with hobs on
handlesupports.
2. insert handle carriage bolts (B) through hobs from
inside of unit and attach a plastic knob (C) from outside
of uniL Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt. the upper handle can fold forward to
store fiat atop the cold engine. DO NOTfold the handle down
while the engine is hot.
3. insert rubber straps (D) through slots (E) in backof
accessorytray and pull tight from fronL
4. Placeaccessory tray (F) over hobs (G) on handle
(viewing from front of unit). Push the tree clips (H) into
the hobs until they sit fiat against the accessory tray.
5. insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided in accessory
tray. SeeHow to UseAccessory Tray,