Operator`s manual

6. Attach bottle bracket (A) to handlewith carriage bolt (B)
and black plastic knob (C). Tighten by hand.
@
Attach Project Pro@ PerfectMix TMSiphon to
Attach the tube end of the blue PerfectMixTM Siphon (t}) to
the barbedtube fitting (E) on the pump.
Attach PerfectNix TMDetergent Siphon to
Concentrategettie
Place PerfectMixTM bottle (not included) in the wire-form
bracket on the handle. Remove cap from bottle and insert the
PerfectMixTM Siphon. Screw the siphon unit to the top of the
bottle (F). Usethe clip on the cap (G)to snap siphon to wire
form bracket when siphon is not in a concentrate bottle.
Add Engine Oil
1. Place pressure washer on a fiat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Slowly pour contents of oil bottle into oil fill opening.
Checking oil level frequently, fill to FULLmark (top hob)
on dipstick.
I Full
NOTICE Pauseto permit oil to settle. Wipe dipstick clean
eachtime oil level is checked. DONOToverfill.
NOTICE improper treatment of pressure washer could
damage it and shorten its life.
, DONOTattempt to crank or start the engine before it has been
properly servicedwith the recommended oil. This could result in
an engine failure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
* Clean,fresh, unleadedgasoline.
* A minimum of 87 octane/87 AKI (91 RON). For high
altitude use, see HighAltitude.
° Gasolinewith upto 10% ethanol (gas@@ is acceptable.
NOTICE Use of unapproved fuels could damage pressure
washer and voids warranty.
DONOTuse unapprovedgasoline such as E15and E85.
DONOTmix oil in gasolineor modify engineto run onalternatefuels.
,a, WARNING Fuel and its vapors are extremely flammable
and explosive which could cause burns,
fire or explosion resulting in death or
serious injury.
WHENADDING FUEL
Turn pressurewasher engineOFFand let it cool at least 2
minutes before removingfuel cap. Loosen cap slowly to relieve
pressure in tank.
Fiii fuel tank outdoors.
* DONOToverfill tank. Allow spacefor fuel expansion.
oif fuel spills, wait until it evaporatesbefore starting engine.
Keepfuel away from sparks, open flames, pilot lights, heat,and
other ignition sources.
Checkfuel lines, tank, cap and fittings frequently for cracks or
leaks. Replaceif necessary.
DONOTlight a cigarette or smoke.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage.All fuel is not the
same. if you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
1. Clean areaaround fuel fill cap, removecap.
2. Slowly add regular unleadedfuel (H) to fuel tank (a). Be
careful not to overfill. To allow for fuel expansion, do not
fill abovethe bottom of the fuel tank neck.
J N _"_*",._N r _'_,,,_
N N
JN N