Operating instructions

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith theassemblyof your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
UNPACKTHEPRESSUREWASHER
1. Removeeverything from carton except pressurewasher.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged,call
the pressure washer helplineat 1-800-222-3136.
• Main Unit
• High PressureHose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• Oil Pouch
• Parts Bag(which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 3 multi-colored Spray Tips
Becomefamiliar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will needassembly before
operation:
1. Fill out and send in registration card.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect pressure hose to spray gun and pump.
AddEngineOil
1. Place pressurewasher on a flat, level surface.
2. Cleanareaaround oil fill and removeyellow oil fill
cap/dipstick.
3. Hold neck of supplied oil pouch and remove cap.
4. Slowly pour contents of oil pouch into oil fill opening.
Checkingoil level frequently, fill to FULLmark (top hole)
on dipstick.
Full
NOTICE Pauseto permit oil to settle. Wipe dipstick clean
eachtime oil level is checked. DONOToverfill.
NOTICE Improper treatment of pressure washer could
damage it and shorten its life.
• DONOT attemptto crank or start the engine before it has been
properly servicedwith the recommended oil. This could result in
an engine failure.
5. Replaceoil fill cap/dipstick and fully tighten.
AddFuel
Fuel must meet these requirements:
• Clean,fresh, unleadedgasoline.
• A minimum of 87 octane/87 AKI (91 RON). For high
altitude use, see High Altitude.
• Gasolinewith upto 10% ethanol (gasohol) is acceptable.
NOTICE Useof unapproved fuels could damage pressure
washer and voids warranty.
• DONOTuseunapprovedgasolinesuchas E15andE85.
• DONOTmixoilingasolineor modifyengineto runonalternatefuels.
5. Connect water supply to pump.
6. Attach nozzleextension to spray gun.
7. Select!attach quick connect spray tip to nozzleextension.