Operating instructions

,
Insert spray gun holder wireform (h) through holejust
above cleaning tank on left side of handle (viewing from
front of unit). Hold wireform in place and attach a plastic
knob (B) from inside of unit. Tighten by hand.
Attach Detergent Siphon Hose to Pump
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (A) to the barbed
hose fitting (B) on the pump.
IMPORTANT:Only one detergent siphoning hose can be used
at a time. When cleaning tank is not used, makesure
detergent shut-off valve on cleaning tank is in the "Off"
position.
Add Enoine OiJ
1. Place pressure washer on a flat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
NOTICE
Improper treatment of pressurewasher can damage it and
shorten its life.
DONOTattemptto crankor starttheenginebeforeit hasbeen
properlyservicedwith the recommendedoil. Thismayresultin
anenginefailure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
* Clean,fresh, unleadedgasoline.
* A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
* Gasolinewith up to 10% ethanol (gasohol) or up to 15%
MTBE(methyl tertiary butyl ether) is acceptable.
NOTICE
Avoid pressure washer damage.
Failureto follow Operator's Manualfor fuel
recommendations voids warranty.
DONOTuseunapprovedgasolinesuchas E85.
DONOTmixoil in gasoline.
DONOTmodifyengineto runon alternatefuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage.All fuel is not the
same. If you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARHIHG
FueIand its vapors are extremely flammable and
explosive.
Fire or explosion can causesevere burns or
death.
WHENADDINGFUEL
. TurnpressurewasherOFFandlet it coolatleast2 minutes
beforeremovingfuelcap.Loosencapslowlyto relievepressure
in tank.
. Fillfueltankoutdoors.
• DONOToverfilltank.Allowspacefor fuel expansion.
. Iffuel spills,waituntil it evaporatesbeforestartingengine.
• Keepfuelawayfromsparks,openflames,pilot lights,heat,and
otherignitionsources.
• DONOTlight a cigaretteorsmoke.
1. Cleanareaaround fuel fill cap, removecap.
2. Slowly add regular unleadedfuel (A) to fuel tank (B). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
3. Installfuel cap and wait for anyspilled fuelto evaporate.