Operator`s manual

Cleaning and Applying Detergent
CAUTION
Chemicalscan causebodily injury, and/or property
damage.
NEVERusecausticliquidwith pressurewasher.
UseONLYpressurewashersafedetergents/soaps.Followall
manufacturersinstructions.
To apply detergent follow these steps:
1. Attach desired detergent siphon hose following
instructions Attach DetergentSiphon Nose to Pump.
IMPORTANT:Be sure engine is off and allowed to cool before
switching detergentsiphoning hoses.
WARNING
_ Contact with muffler result in serious
area can
burns.
_ Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
. DONOTtouchhot partsandAVOIDhot exhaustgases.
• Allowequipmentto cool beforetouching.
2. Review use of spray tips.
3. Preparedetergent solution as required by job.
4. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
5. If using cleaning tank, pour detergent into cleaning tank.
NOTE:The cleaning tank holds one gallon.
6. Make sure black detergent spray tip is installed.
NOTE:Detergentcannot be applied with the high pressure
nozzles (White, Yellow or Red).
7. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOtiCE
You must attach all hoses before ou start the enine.
Startingthe enginewithoutallthe hosesconnectedandwithout
the waterturnedONwill damagethe pump.
Damageto equipmentresultingfrom failureto followthis
instructionwill void warranty.
8. Start engine following instructions How to Start Your
Pressure Washer.
9A. If using cleaning tank, rotate detergentshut-off valve on
cleaning tank to "On" position (A).
IMPORTANT:if using detergent siphoning hose, make sure
detergentshut-off valve on cleaning tank is in the "Off"
position.
9B. If using detergent siphoning hose, place small filter end
of detergent siphoning tube into detergent container.
NOTE:Makesure the filter is fully submerged in detergent
while applying detergent.
NOtiCE
Contact with the hot muffler can damage detergent
siphoning tube.
Wheninsertingthe filterinto a detergentsolutionbottle,route
thetubeso asto keepit from inadvertentlycontactingthe hot
muffler.
10. Apply detergentto a dry surface, starting at lower
portion of areato be washed and work upward, using
long, even, overlapping strokes.
11. Allow detergentto "soak in" for 3-5 minutes before
washing and rinsing. Reapplyas neededto prevent
surface from drying. DO NOTallow detergent to dry on
(prevents streaking).
Pressure Washer Binsing
For Rioting:
1. If using cleaning tank, rotate detergent shut-off valve on
cleaning tank to "Off" position.
2. Remove blackspray tip from nozzleextension.
3. Selectand install desired high pressure spray tip
following instructions How to Use Spray Tips.
4. Keepspray gun a safe distance from areayou plan to
spray.
__ spray gun can causeyou
Kickbackfrom to fall.
• Operatepressurewasherfrom astablesurface.
. Beextremelycarefulif you mustusethe pressurewasherfrom
a ladder,scaffolding,or anyothersimilarlocation.
• Firmlygraspspraygunwith both handswhenusing high
pressuresprayto avoidinjury whenspraygunkicksback.
Apply a high pressure spray to a small areaand then
check surface for damage.If no damage is found, you
can assume it is okayto continue rinsing.
Start at top of areato be rinsed, working down with
same overlapping strokes as you used for cleaning.
Automatic Cool Down System (Thermal Refief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F.The system engagesto cool the pump by discharging
the warm water onto the ground.
14