Operator`s manual

.
Insert spray gun holder wireform (A) through hotejust
above cleaning tank on ieft side of handle (viewing from
front of unit). Hold wimform in place and attach a piastic
knob (B) from inside of unit. Tighten by hand.
l
Attach Detergent Siphon Hose to Pump
The pressure washer is equipped with two detergent
siphoning hoses. One is attachedto the cleaningtank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (A) to the barbed
hose fitting (B) on the pump,
IMPORTANT:Only one detergent siphoning hose can be used
at a time. When cteaningtank is not used, makesure
detergent shut=off valve oll cleaningtank is in the "Off"
position.
Add Engine Oil
1. Place pressure washer on a fiat, bvei surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
NOTE:See Oi/Recommendations in Ma,_otenancesection.
Verify provided oii bottle is the correct viscosity for current
ambient temperature.
3. Using oii funne! (optional), sIowiy pour contents of
provided oil bottle into oil fill opening.
improper treatment of pressurewasher can damage it and
shorten its iife.
DONOTattempttocrankor stat the enginebeforeit hasbeen
properlyservicedwiththe recommendedoil. Thismayresultin
anenginefailure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
. Clean,fresh, unleadedgasoline.
o A minimum of 87 octane/87AKi (91 RON). High altitude
use, see High A/titude.
. Gasoiinewith up to 10% ethanoi (gas@@ or up to 15%
MTBE(methyl tertiary butyl ether) is acceptable.
Avoid pressure washer damage.
Failureto follow Operator's Manualfor fuel
recommendations voids warranty.
DONOTuseunapprovedgasolinesuchasE85.
DONOTmixoil in gasoline.
DONOTmodifyengineto runon alternatefuels.
To protect the fuel system from gum formation, mix in a fuel
stabiiizer when adding fueI. See Storage.AIi fueI is not the
same. if you experiencestarting or performance probiems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifbations).
WARNING
Fueland its vapors are extremely flammabb and
explosive.
Fire or explosion can causesevere burns or
death.
WNENADDINOFNEL
o TurnpressurewasherOFFandlet it coolat least2 minutes
beforeremovingfuelcap.Loosencapslowlyto relievepressure
in tank.
o Fillfuel tankoutdoors.
• DONOToverfilltank.Allowspaceforfue!expansion.
o Iffuel spills waituntil it evaporatesbeforestartingengine.
• Keepfuelawayfrornsparks,openflames,pilot lights,heat,and
otherignitionsources.
DONOTlight a cigaretteorsmoke.
Cleanareaaround fuet filI cap, removecap.
Siowiy add regular unleadedfuel (A) to fuet tank (B). Be
carefui not to overfiii. Aliow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
®
1.
2.
3. Install fuel cap and wait for anyspilled fuel to evaporate.