Operator`s manual

HOWTO USEYOURCLEANINGSYSTEM
If you haveany probbms operating your pressure washer,
please call the pressure washer heJpfineat 1-800-222-3136,
Pressure Washer Lecation
PressureWasherCJearance
VANNING
Exhaustheat/gases can ignite combustibbs,
structures or damage fuei tank causing a fire.
o Keepat least5ft. (152cm)clearanceonall sidesof pressure
washerincludingoverhead.
Macepressure washer outdoors in an areathat wiii not
accumulate deadtyexhaust gas. DONOTpiace pressure
washer where exhaust gas (A) could accumulateand enter
inside or be drawn into a potentiaily occupied building.
Ensureexhaust gas is kept awayfrom any windows, doors,
ventiiation intakes, or other openings that can aliow exhaust
gas to coiiect in a confined area. Prevaiiingwinds and air
currents should be taken into considerationwhen positioning
_ressurewasher.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathingcarbon monoxide can causeheadache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea,fainting or death.
° OperatepressurewasherONLYoutdoors.
o Keepexhaustgasfromenteringaconfinedareathrough
windows,doors,ventilationintakes,or otheropenings.
• DONOTstat or runengineindoorsor in anenclosedarea,
evenif windowsanddoorsareopen.
To Start Your CmeaningSystem
To start your engine=poweredcleaning system for the first
time, foiiow these instructions step=by=step.This information
also applies wheneveryou start the engine after you have let
the pressure washer sit idle for at bast a day.
1= Placepressure washer nearan outside water source
capable of supplying water at a flow rategreater than
3.5 galions per minute and no iess than 20 PSi at
pressurewasher end of garden hose.
2. Checkthat higil pressure hose is tightly connected to
spray gun and pump. SeeAssemby for illustrations.
3. Makesure unit is in a ievei position.
4. Connectgarden hose to water intet on pressure washer
pump.
5. Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
6. Attach PrecisionSprayTM Selectorto spray gun according
to PrecisionSprayTM Selector instruction sheet.
7. Engagetrigger lock (A) to spray gun trigger.
8. Movethrottle lever (Ai to "Fast position, shown hereas
a rabbit.
9. Move choke iever (B) to "Choke" position.
NOTE:For a warm engine, be sure the choke leveris in the
"Run" position.
iMPORTANT:Before starting the pressurewasher, be sure
ou are wearing adequatesafety goggbs.
WARNING
>_ iRiskof eYeinjurY.
" |Spraycan splash back or propel objects.
Alwayswearsafetygoggleswhenusingthis equipmentor in
vicinityof whereequipmentis inuse
Beforestartingthe pressurewasher,besureyouarewearing
adequatesafetygoggles.
NEVERsubstitutesafetyglassesfor safetygoggles.
10