Operating instructions

Before connecting garden hose to water inlet, inspect

inlet screen. Cleanscreen (A) if it contains debris or have

it replacedif damaged.DO NOTrun pressurewasher if

inlet screenis damagedor missing.

4. Run water through garden hose for 30 seconds to flush

it of debris. Turn off water.

IMPORTANT:DO NOTsiphon standing water for the water

supply. UseONLY cold water (less than IO0°F).

5. Connect garden hose (not to exceed50 feet in length) to

water inlet. Tighten by hand.

NOTICE

Using a OneWay Valve (vacuum breaker or check valve)

at pump inlet can cause pump or inlet connector damage.

ThereMUSTbeat leastten feet(3m) of unrestrictedgarden

hosebetweenthepressurewasherinletandanydevice,suchas

avacuumbreakeror checkvalve.

Damageto equipmentresultingfromfailureto followthis

instructionwill voidwarranty.

6. Turn ONthe water, press red button (B) on the gun and

squeezethe trigger to purge the pump system of air and

impurities.

WARHIHG

_Risk of injury.

eye

ISpray can splash back or propel objects.

Alwayswearsafetygoggleswhenusingthis equipmentor in

vicinityof whereequipmentisin use.

Beforestartingthe pressurewasher,besureyouarewearing

adequatesafetygoggles.

NEVERsubstitutesafetyglassesfor safetygoggles.

CheckJistBeforeStartingEngine

Reviewthe unit to ensure you have performed all of the

following:

1. Besure to read Safety Rules and Operationsections

before using the pressure washer.

2. Makesure handle is in place and secure.

3. Checkthat oil has beenadded to proper level in engine

crankcase.

4. Add proper fuel to fuel tank.

5. Checkfor proper hose connections (high pressure and

water supply) and that there are no kinks, cuts, or

damageto the high pressure hose.

6. Provide proper water supply (not to exceedIO0°F).