Operating instructions

HOWTO USEYOURPRESSUREWASHER
If you haveany problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Location
PressureWasherClearance
,_ WARNING
_ Exhaustheat/gases can ignitecombustibles,
structures or damage fuel tank causing a fire.
* Keepat least5ft. (152cm)clearanceonall sidesof pressure
washerincludingoverhead.
Placepressure washer outdoors in an areathat will not
accumulate deadly exhaust gas. DO NOTplace pressure
washer where exhaust gas (A) could accumulateand enter
inside or be drawn into a potentially occupied building.
Ensureexhaust gas is kept awayfrom any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailingwinds and air
currents should be taken into consideration when positioning
_ressurewasher.
,_ WARHJHG
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
_ reathing carbon monoxide can causeheadache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea,fainting or death.
. OperatepressurewasherONLYoutdoors.
. Keepexhaustgasfromenteringaconfinedareathrough
windows,doors,ventilationintakes,or otheropenings.
• DONOTstartor runengineindoorsor in anenclosedarea,
evenif windowsanddoorsareopen.
To Start Your Pressure Washer
To start your engine-powered pressurewasher for the first
time, follow these instructions step-by-step. This information
also applies wheneveryou start the engine after you have let
the pressure washer sit idle for at leasta day.
1. Placepressure washer nearan outside water source
capable of supplying water at a flow rate greater than
3.8 gallons per minute and no less than 20 PSI at
pressurewasher end of garden hose.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. SeeAssemblyfor illustrations.
3. Makesure unit is in a level position.
4. Connectgarden hose to water inlet on pressure washer
pump.
5. Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
[ NOTICE
DO NOTrun the pump without the water supply connected
and turned on.
L amageto equipmentresultingfrom failureto followthis
instructionwill void warranty.
6. Attach spray tip extension to spray gun. Tighten by
hand.
7. ChooseQuick Connectspray tip you want to use, pull
back on collar of spray tip extension, insert spray tip and
releasecollar. Tug on spray tip to make sure it is
securely in place. SeeHow to Use OuickConnect Spray
tip System.
8. Rotate fuelshut-off valveto "On"position (B) (fully
counter-clockwise).