Operating instructions

PressureWasherRinsing
ForRinsing:
1. Remove soap spray tip from spray tip extension.
2. Selectand install desired high pressurespray tip
following instructions How to Use Ouick ConnectSpray
tip System.
3. Keepthe spray gun a safe distance from the areayou
plan to spray.
WARHIHG
spray gun can cause you
Kickbackfrom to fall.
• Operatepressurewasherfrom astablesurface.
, Beextremelycarefulif youmust usethe pressurewasherfrom
a ladder,scaffolding,or anyothersimilarlocation.
, Firmlygraspspraygunwith bothhandswhenusinghigh
pressuresprayto avoidinjury whenspraygunkicksback.
4. Apply a high pressure spray to a small area, then check
the surface for damage.If no damage is found, it is okay
to continue cleaning.
Start at the top of the areato be rinsed, working down
with same overlapping strokes as you used for washing
and applying detergent.
,
Cleaning DetergentSiphoning Tube
If you used the clear detergent siphoning tube, you must
flush it with clean water before stopping the engine.
1. Placedetergent siphoning tube/filter in a bucket full of
clean water.
2. Remove high pressurespray tip from spray tip
extension.
3. Selectand install a soap spray tip following instructions
How to Use Ouick Connect Spray Tips.
4. Flushfor 1-2 minutes.
5. Shut off engine following instructions How to Stop
Pressure Washerand turn off water supply.
6. ALWAYS point spray gun in a safe direction push red
button and squeezespray gun trigger to release retained
high water pressure.
WARHIHG
The high pressure stream of water that this
_ equipment produces can cut through skin and its
lunderlying tissues, leading to serious injury and
ipossible amputation.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button and
squeezespray gun trigger, to releasehigh pressure, every time
you stop engine.
iMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F.The system engagesto cool the pump by discharging
the warm water onto the ground.
16