Operating instructions

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you haveany problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKPBESSUREWASHER
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting each corner from top
to bottom.
7. Attach spray tip extension to spray gun.
8. Select/attachQuick Connectspray tip to spray tip
extension.
Attach Handle and Accessory Tray
1. Placehandle (A) onto handlesupports (B) connectedto
main unit. Make sure holes (C) in handlealign with holes
(C) on handle supports.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged,call
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Accessory Tray
* High PressureHose
* Spray Gun
* Spray tip Extensionwith Quick Connect Fitting
* Bottle BracketWireform (2)
* PerfectMixTMSiphoningUnit/Hose
* StandardSiphoning Hose
* Oil Bottle
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* Safety Goggles
* Bagcontaining 4 multi-colored Quick Connect
Spray tips
* HandleFasteningHardwareKit (whichincludes):
* Carriage Bolts (4)
* Plastic Knobs (4)
, Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. if any parts are missing or damaged,call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle, accessory tray and bottle brackets.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
NOTE:It may be necessaryto move the handle supports
from side to side in order to align the handle so it will slide
over the handlesupports.
2. Insert carriage bolts (D) through holes from back of unit
and attach a plastic knob (E)from front of unit. Tighten
by hand.
3. Placeaccessory tray (F) over holes (6) on handle
(viewing from front of unit). Push the tree clips (H) into
the holes until they sit flat againstthe accessory tray.
Insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray. SeeHow to UseAccessory Tray.