Operating instructions

HOWTO USEYOURPRESSUREWASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
PressureWasherLocation
PressureWasher Clearance
_k WARNING Exhaust heat/gases can ignite
combustibles, structures or damagefuel tank
causing a fire.
• Keepat least5 ft. (152 cm) clearanceon all sides of pressure
washer including overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOTplacepressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept awayfrom any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in aconfined area. Prevailing winds and air
currents should be taken into consideration when positioning
_ressurewasher.
_k WARNING Running enginegives off carbon
monoxide, an odorless, colorless, poisonous gas.
_ Breathing can cause headache,
carbon monoxide
fatigue, dizziness,vomiting, confusion, seizures,
nausea,fainting or death.
• OperatepressurewasherONLYoutdoors.
• Keepexhaustgasfromenteringa confinedareathrough
windows,doors,ventilationintakes,or otheropenings.
• DONOTstartor runengineindoorsor in anenclosedarea,
evenif windowsanddoorsareopen.
To Start YourPressure Washer
To start your engine-powered pressurewasher for the first
time, follow these instructions step-by-step. This information
also applies wheneveryou start the engine after you have let
the pressure washer sit idle for at leasta day.
1. Place pressurewasher outside nearan water source
capableof supplying water at a flow rate greater than
3.7 gallons per minute and no less than 20 PSi at
pressurewasher end of garden hose.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. SeeAssembly for illustrations.
3. Makesure unit is in a level position.
4. Connectgarden hose to water inlet on pressurewasher
pump.
NOTICE DO NOTrun the pump without the water supply
connected and turned on.
• Damageto equipmentresultingfromfailureto followthis
instructionwill voidwarranty.
5. Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
6. Attach nozzleextension to spray gun. Tighten by hand.
|l ml I|
.
Pull backon collar of nozzleextension, insert selector
nozzleand releasecollar. Tug on selector nozzleto make
sure it is securely in place. See How to UseSelector
Nozzle.
8. Push engine rocker switch (B) to on position (I or ON).
\
11