Operating instructions

CARTON CONTENTS
The following parts are shippedloose with your pressure
washer:.
* Main Unit -- pressurewasher with wheels,
guide handle.
• High Pressure Hose
• Manual Bag (which includesthe items listed below)
• Ov_er's Manual
* Nozzle Cleaner Kit
• Parts Box (which includes items listed below)
• Spray Gun
• Wand Extensionwith Hi/Lo AdjustableNozzle.
• Wire Form
• MotorOil
• "O"-Ring Kit
Become familiar with each piece before assemblingthe
pressure washer. Check all contentsagainst the illustra-
tion on Page 6. If any parts are missingor damaged, call
the Pressure Washer Helplineat 1-800-222-3136.
TO REMOVE PRESSURE WASHER FROM
CARTON
Removeloose parts and parts box includedwith pres-
sure washer. The highpressure hose is packed in the
bottom of the carton on the guide handle end.
Remove the hose.
• Slice two comers at guide handle end of carton from
top to bottom so the panel can be folded down fiat,
then remove all packingmaterial.
• Raise guide handle, secure in place and'rollthe pres-
sure washer out the open end ofthe carton.
Loosen knobs
to raise handle
HOW TO SET UP YOUR PRESSURE WASHER
Forthe most part, yourCraftsmanHigh PressureWasher
has been assembledatthe faclonj. You must, however,
attachthe wire form, assemble the spray gun,and attach
the high pressurehose to the pump and spraygurL
• While facing the rear of the Pre_;sureWasher, insert
the wire supportwiththe longer arm positk)nedon the
left. From this view the hook should resemble a =,r'.
• Cut_ wrapon chemicalinjecliontube. Removechami-
cal injectionfilter,threadchemicalinjectiontubethrough
the wireform andreinsertIilterintotube.
Tighten knobs
when handle is
straight.
• Check carton for additionalloose parts.
4