Manual

HighAltitude
At altitudesover5,000 feet (1524meters),a minimum 85 octane
/ 85 AKI (89 RON)gasolineis acceptable.To remainemissions
compliant,high altitudeadjustmentis required.Operationwithout
this adjustmentwill causedecreasedperformance,increasedfuel
consumption,and increasedemissions.Seea qualifiedSears
dealerfor highaltitudeadjustmentinformation.Operationof the
engineat altitudesbelow2,500 feet(762 meters)with the high
altitudekit is not recommended.
Connect Hose and Water Supply to Pump
NOTE:Removeand discardthe shipping caps from the pump's
high pressureoutlet andwater inlet beforeattaching hoses.
NOTICE
DO NOTrun the pump without the water supply connected
and turned on.
Damageto equipmentresultingfrom failureto followthis
instructionwill void warranty.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARHIHG
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, leadingto serious injury and
_ossibleamputation.
* NEVERconnecthighpressurehoseto spraytip extension.
* Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
* Alwaysbecertainspraygun,spraytips andaccessoriesare
correctlyattached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
,
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged.DO NOTrunpressurewasher if
inlet screenis damagedor missing.
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT:DO NOTsiphon standing water for the water
supply. Use ONLYcold water (less than I O0°F).
HOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
ThereMUSTbeat leastten feetof unrestrictedgardenhose
betweenthepressurewasherinletandanydevice,suchas a
vacuumbreakeror checkvalve.
Damageto equipmentresultingfrom failureto followthis
instructionwill void warranty.
5. Connectgarden hose (not to exceed50 feet in length) to
water inlet. Tighten by hand.
WARHIHG
,_ Risk of eye injury.
_Spray can splash back or propel objects.
Alwayswearsafetygoggleswhen usingthis equipmentor in
vicinityof whereequipmentis in use.
Beforestartingthe pressurewasher,besureyouarewearing
adequatesafetygoggles.
NEVERsubstitutesafetyglassesfor safetygoggles.
6. Turn ON the water, press red button (B) on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Checklist Before Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Besure to read Safety Rules and Operationsections
before using the pressure washer.
2. Makesure handle is in place and secure.
3. Checkthat oil has beenadded to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceedIO0°F).
10