Manual

Check High Pressure Hose
High pressure hoses can develop leaks from wear, kinking,
or abuse. Inspect hose before each use. Checkfor cuts,
leaks, abrasions, bulging of cover, or damage or movement
of couplings. If any of these conditions exist, replace hose
immediately.
WARHIHG
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, leadingto serious injury and
_ossibleamputation.
* NEVERrepairhighpressurehose.Replaceit.
* ReplacementhoseratingMUSTexceedmaximumpressure
ratingof unit.
Check Gun and Hozzle Extension
Examinehoseconnectionto spraygun and makesure it is
secure.Testtrigger by pressingit and makingsure it springs
backinto placewhenyou releaseit. Do notdepressred button
andtest trigger.Youshould not beableto presstrigger. Replace
spraygun immediatelyif it failsany of thesetests.
HozzleMaintenance
A pulsing sensation felt while squeezingthe spray gun trigger
may becaused by excessive pump pressure. The principal
cause of excessive pump pressure is a nozzleclogged or
restricted with foreign materials, such asdirt, etc. To correct
the problem, immediately clean the nozzlefollowing these
instructions:
1. Shut off engine and turn off water supply.
2. ALWAYSpoint spray gun in a safe direction, press red
button and and squeezespray gun trigger to release
retained high water pressure.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
* Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
* ALWAYSpointspraygunin safedirection,pressredbutton
andsqueezesprayguntrigger,to releasehighpressure,every
time youstopengine.
3. Remove nozzlefrom end of nozzleextension.
4. Usea small paperclip to free any foreign material
clogging or restricting nozzle (A).
,
6.
Remove nozzleextension from spray gun.
Using a garden hose, removeadditional debris by back
flushing water through nozzleextension. Backflush
between30 to 60 seconds.
7. Reinstallnozzleinto nozzleextension.
8. Reconnectnozzleextension to spray gun.
9. Makesure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
10. Start engine following instructions How to Start Your
Pressure Washer.
11. Test pressure washer by operating with each quick
connect nozzle.
O-Ring Maintenance
Purchasean O-Ring Repair Kit atyour local Sears or by
calling 1-800-4-NIY-HOIVlE(469-4663) or online at
www.sears.com. It is not included with the pressure washer.
This kit includes replacement o-rings, rubber washer and
water inlet filter. Referto the instruction sheet provided in the
kit to service your unit's o-rings.
WARHIHG
The high pressurestream of water that this
,p_ equipment produces can cut through skin and its
underlying tissues, leadingto serious injury and
)ossible amputation.
* NEVERrepairleakingconnectionswith sealantof anykind.
Replaceo-ringor seal.
18