Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHEPRESSUREWASHER
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting eachcorner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents. If any parts are missing or damaged,call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High PressureHose
• Spray Gun
• NozzleExtensionwith Quick Connect Fitting
• Oil Bottle
• HoseWrap
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• Bottle BracketWirdorm (2)
• PerfectMixTM Siphoning Unit/Hose
• DetergentSiphoning Hose/Filter
• Bagcontaining 5 PrecisionSprayTM Nozzles
• FreshStart FuelCartridge
• HandleFasteningHardwareKit (whichincludes):
• Handle Bolts (2)
• Carriage Bolt (2)
• Plastic Knobsfor Handle (2)
• Rope Guide (1)
• Plastic Knob (3)
• Tree Clips (4)
Becomefamiliar with each piece before assemblingthe
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged,call the
pressure washer helpline at 1-800-222-3136.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank and FreshStart fuel cartridge to fuel
cap.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attachquick connect PrecisionSprayTM nozzleto
nozzleextension.
Attach Handle and Accessory Tray
1. Placehandle (A) onto handlesupports (B) connected to
main unit. Make sure holes (C) in handlealign with holes
(C) on handle supports.
,
....
is
2. Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E)from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine.
NOTE:DONOTfold the handle down while the engine is hot.
Placeaccessory tray (F) over holes (6) on handle
(viewing from back of unit). Pushthe tree clips (H) into
the holes until they sit flat againstthe accessory tray.
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle, accessorytray, rope guide and hose wrap.
3. Connect detergent siphon hose to pump.
, L I I
Insert multi-colored PrecisionSprayTM nozzlesand other
supplied accessories in spaces provided in accessory
tray. SeeHow to UseAccessory Tray.