Manual
Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water
supply connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTICE Remove and discard the shipping caps from
attaching hoses.
1. Uncoil high pressure hose and attach one end of
2. Attach other end of high pressure hose to high
3. Before connecting garden hose to water inlet,
inspect inlet screen (A). Clean screen if it contains
DO NOT run
pressure washer if inlet screen is damaged or
missing.
4. Run water through garden hose for 30 seconds to
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
NOTICE
check valve) at pump inlet could cause pump or inlet
connector damage.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
B) on the gun
and squeeze the trigger to purge the pump system of
air and impurities.
Checklist Before Starting Engine
Review the unit to ensure you have performed all of the
1. Be sure to read Safety Rules and Operation
2. Make sure handle is in place and secure.
engine crankcase.
4. Add proper fuel to fuel tank.
5. Check for proper hose connections (high pressure
and water supply) and that there are no kinks, cuts,
or damage to the high pressure hose.
11
B
A
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
amputation.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
are correctly attached.
WARNING Risk of eye injury.
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
or in vicinity of this equipment.
for indirect vented safety goggles.