52 owner's manuah MODEL NO. 636.796670 BUSHWACKER CAUTION: Read Rules for e Assembly o Maintenance . Operation o Repair Parts Safe Operation and instructions Carefully Sears, 5209500101 4/89 Roebuck and Co., Chicago, IIL 60684 U.S.A.
TWO Fo_ two years from date o{ YEAR purchase LIMITED WARRANTY ON CRAFTSMAN BUSHWACKER 636.796670 when this BUSHWACKER is maintain6_, tubricated, and tuned up according to the operating and maintenance instructions in the owner's manual. Sears will repair free of charge any defect In material or workmanship This warranty excludes blades, spark plug_ and air cleaner: which are expend_He part.
KNOW Your new B[JSHWACKER YOUR has been carefully however, even with the best of preventative check out procedures listed below: BUSHWACKER packed measures, at the factory to prevent damage does sometimes occur damage during shipping It is recommended and storage, that you follow the Remove all items from the carton, lay them out and check the parts Io be sure that you have everything required for assembly. Also check carefully for any visible damage.
PREPARaHG FOR OPERATaON 5. To avoid operation Handle a burn, do not or immediately the engine after touch after the engine during the stopping the englne_ it is completely cooled. Fuel and oil mixture inspect the fuel tank and flit with clean, fresh fuel of the proper mixture This engine requires a mixture of t6 parts gasofine to t part oil (1 gal gasoline oil) Use 71-36555 Craftsman b_vo cycle engine oi!. Engine 6 to 8 oz Oil or a high grade Never operate standing 7.
3. Puli the throttle and lock (Figure lever a little, the throttle push the lever at the starting throttle knob without a load, otherwise speed reducing engine life. position. the engine will run at a high 3} Stopping the Engine I Reduce the engine rpm to idle by releasing 2 Set the stop switch to stop.
Carburetor Proper adjustment of the carburetor is very important to the operation of this engine.
_AB_TS_A_C_ In every 10--20 grease through 2 hours, inject one or two ounces of Stop cutting weight the engine before tubricatirrg operation, Frequent oil during cutting will the blades during the lubrication using a light greatly add to blade life, a grease nippFe installed in the gear case of the BUSHWACKER Be sure the engine while greasing the gear case is stopped Figure 8 Figure 7 __________________________________________________________________________u__________________________
\ €_ r_ \ r_O Cr_ LU 0 iU_ LL_ 0_
×= U_ cI €_ r,, o .J E < r_ ..= U.
L, Q l")"l i,L! Q 0 €.d) t,,- i.i,t z U.
z o w >: to o r_ 0 t,,,,i I,& w -6 2 o Z 8 ,rj S I-, t_ 11
© \° C3 r,, c_ .J LU C_ 0 Ct) .
Z o p,, "= _,8 ,,.,,I I.u Q 0 ,J .Q W €,.I x'.
The Model Number mention the Model for your unit. will be found on the top of recoil st artero Always Number When requesting service or repair parts All parts listed herein may be ordered from any SEARS, ROEBUCK AND CO,. OR SIMPSONS_SEARS LIMITED service units or most retail stores. WHEN ORDERING REPAIR PARTS, FOLLOWING INFORMATION AS SHOWN 1.
