OPERATOR'S MANUAL CRAFTSMAN HEAVY DUTY TOOL CHESTS * Product you purchased may vary from picture shown SERVICE PARTS CALL 1-800-366-7278 FOR SERVICE PARTS. Refer to Service Parts Drawing for full listing of Service Parts. LOCATING MODEL # INFORMATION Mode! numbers and other information required for service parts is located on a label on the interior right side of the top most drawer, Hess + The maximum weight for each drawer should be no more than 75 ibs.
HARDWARE TOOLS REQUIRED: 38-0 Wrench Ranch Crass-tip Screwdriver HARDWARE INCLUDED: 26-INCH CABINET HARDWARE TD (ome HARDWARE INCLUDED: ANCHOR CABINET HARDWARE Hi-in Hex Berates (Oty: Cross-tip Screw (Qty: 34-In Bowers (Oty: 16) spans, 174 20 x 58 Screw (Qty: 16 ne awe A 3 14-in Mut (Qty: 16) iE iEl a NOTE: Not all assembly instructions will relate to your mode! £5 SIDE HANDLE ATTACHMENT items Needed: Gross-tip Sower (Gly: 4) Cross-LP Screwdriver Process: « Attach the side handle using Cross-tip S Crews, «
HS LABELS (IF APPLICABLE) Process: « Apply a fight film of glass o the able is to be applied. « Peel the label from the backing and place the label in position + Chuck alignment of the label and adjust accordingly. + Hold the [anal in position and squeegees off excess liquid with a towed, working from the center toward each end of the label. « Suggested label location is shown, tenner to the surface where eae i Ee % REMOVING DRAWERS 5 Empty the drawer » Fully extend the drawer.
cn . ETIQUETAS (81 APLICA} £2 PINTALABIOS DE GAVETAS be Proceso: Correderas de rodamientos esféricos jale hacia afuera « Aplica una capa fina de Empleador para divos en la fas correderas y ef posarte de las corderas hasta que superficie donde se colocar la etiqueta quedan an posición totalmente extendida (ver Lustración) = Quite of revestimiento de ta etiqueta v columelar en su Sostenga is corredera en el gabinete mientas lo alinea sitio.