OPERATOR'S MANUAL CRAFTSMAN WORKBENCH “Product you purchased may vary from picture shown PELE GITE CALL 1-800-469-4663 FOR SERVICE PARTS. Refer to Service Parts Drawing for full listing of Service Parts. LOCATING MODEL # INFORMATION Model numbers and other information required for service parts is located on a label on the interior right side of the frame amendment. (aE +The maximum combined weight limit should not exceed 3,000 Ibs.
PLL JEER EAN LES Process: + Assemble Frame Amendment as shown to the bottom of TOOLS REQUIRED: A. Back Stop Items Needed: the Workbench Top following the illustration below and Socket Wrench &. Workbench Top Leg Amendment (Qty: 4) aligning the per-drilled holes using (12) 3/8-7 x 1" Hex 9/16" Socket or 9/16" Wrench C. Frame Amendment 2) Screw Leveler (Qty: 4) screws. 3/8" Socket or 3/8" Wrench D. Leg Amendment (4) P «Tighten screws so frames do not fall, but are still 1/2" Socket or 1/2" Wrench E.
0 Items Needed: Rail (Qty:1) 5416-18 x Carriage Bolt (Qty 4) Flange Nut (Qty:4} Process: + Attach Rail as shown using {4} x carriage bolts and (4) Flange nuts. Flanges of rail should face towards the front of the workbench. Adjust back Leg Amendment to desired height before attaching bots. Items Needed: Rack Stop (Qty: 1) #14-10 x 5/8" Hex Screw (Qty: 6} Process: « Place the workbench in its upright position.
MANUAL DE USUARIO MANTENIMIENTO FERRETERÍA CONTENIDO DE LA CAJA DE CARTÓN + Las superficies deben limpiarse periódicamente con un detergente HERRAMIENTAS NECESARIAS: A.Tope posterior ® suave'y agua. Llave de dado B. Superficie def banco de trabajo + La grasa el aceite pueden retirarse con la mayoría de los líquidos Dado de 9/16" ¢ llave de 9/16" C. Ensamblaje del armazón (2) estándar para limpieza. Por razones de seguridad, utilice un liquido Dado de 3/8" 0 lave de 3/8" D.
NY Artículos Necesarios: Ensamblaje de fas patas (Cantidad 4 Nivelador de tornillo {Can: 4} Proceso: » Ensambla 2 niveladores de tornillo en cada ensamblaje de las patas. Pueden ser necesarios algunos ajustes después de que el trabajo esté en la posición deseada. Ensamblaje de las patas Nivelador & Artículos Necesarios: Ensamblaje del armazón (Can: 2} Proceso: « Coloca la superficie del banco de trabajo con el lado superior hacia abajo. (Usa el material de empegue para evitar rayones).