Operator's Manual 12-in. 18 Volt Weedwacker® Cordless Trimmer Model No. 172.74815 CHARGE BATTERY BEFORE FIRST USE CAUTION: Read, understand and follow all Safety Rules and Operating Instructions in this Manual before using this product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A Visit our Craftsman® website: www.craftsman.
Warranty............................................................................................ Safety Symbols ................................................................................... Page Page 2 3 Safety Instructions ................................................................................ Unpacking........................................................................................ Pages Page 4- 10 11 Description .............................................................
PERSONAL SAFETY cont. _NARNING: if correctly used, this cordless trimmer is an easy to handle and efficient tool; if used improperly or without the due precautions it could become a dangerous tool. For pleasant and safe work, ALWAYS strictly comply with the safety rules that are contained in this manual. /!X WARNING: BE SURE to read and understand all instructions in this manual before using this cordless trimmer.
ELECTRICAL SAFETY cont. SAFETY RULES FOR CORDLESS TRIMMERS cont. 3. Do not abuse the cord on the charging stand. Never carry the charging stand by its power cord. Never pull the power cord to remove the charging stand from the power outlet. Damage to the cord or charging stand could occur and create an electric shock hazard. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of electric shock.
SAFETY RULES FOR CORDLESS TRIMMERS cont. SAFETY RULES FOR BATTERY CHARGING STAND cont. Z_ CAUTION: USE ONLY the specifically designated battery charging stand that was supplied with this trimmer when charging the battery pack. The use of any other battery charging stand could damage the battery pack, and create a hazardous condition. 23. BEFORE using the trimmer, remove any stones, sticks, debris or objects that could be entangled in or thrown by the trimmer. 24.
SAFETY RULES FOR BATTERY CHARGING STAND cont. 1. The trimmer comes assembled except for the guard and auxiliary which must be attached. 10. Do not disassemble charging stand.Take it to a Sears Parts and Repair Center when service or repair is required, incorrect reassembly may result in a risk of electric shock or fire. 2.
KNOWYOUR CORDLESSTRIMMER (Fig. 2) KNOW YOUR CORDLESSTRIMMER NOTE: Before attempting to use this product, familiarize operating features and safety rules. yourself with all Fig. 2 Safety "On" Button Safety, performance and dependability have been given top priority in the design of this product, making it easy to maintain and operate. This Cordless Trimmer has the following cont. (Fig. 2) Trigger Switch Handle Trigger Switch features: 1 12=inch Cutting Path 2. Twist and Edge...
CHARGING THE BATTERY PACK cont. (Fig. 3 and 3a) Cutting Path 12 inches Speed 7000 RPM Rating 18.0 Volt Line Diameter 0.065-inch twisted line Line Feed Mechanism Automatic Power Head Tilt 4 positions Adjust Height of Shaft From 16 to 25 inches Charging Stand input 12OV,60Hz AC Charge Rate I hour Charging Stand Number CGTt 83UA-48 (C1817A005) Battery Pack Number CGTt 83UA-42 (WA 3127) i . i Fig. 3 Fig. 3a The charging stand has two (LED) indicator lights, one green and one red.
iNSTALLiNG THE BATTERY PACK (Fig. 4) INSTALLING THE SAFETY GUARD (Figs. 5 and 5a) 1. Remove the battery pack from the trimmer. Fig. 4 2. Turn the trimmer's motor housing head over to provide access to underside base of the head by the cutting line spool. 3. Locate the single screw in the base of the head and remove the screw. 4. Insert the edge of the safety guard into the slot along the back of the trimmer's head, carefullly lining the screw hole in the guard up with the screw hole in the trimmer head.
ATTACHING THE AUXiLiARY HANDLE (Fig. 7 and 7a) ADJUSTINGTHE NOTE: THE AUXiLiARY HANDLE MUST BE ATTACHED to the trimmer before use. 1. shaft Remove the battery pack from the trimmer. Z_ WARNING: To avoid injury, ALWAYS remove the battery from the trimmer BEFORE installing parts or cleaning the trimmer or making any adjustments. Unscrew the auxiliary handle's tightening knob (counterclockwise) and remove from handle. 2. ] 3.
TO USETRIMMER FOR EDGING: ROTATE REAR HANDLE AND UPPER SHAFT 180° (Figs. 10, 11, 11a and 11b) trimmer 1 I TRIMMING AND EDGING (Figs. 13 and 14) When trimming, cut from left to right for cutting efficiency; this throws the clippings away from the operator (Fig. t3). 1. Remove the battery pack from the trimmer• To edge, rotate the shaft 180° (See Page 20, Figs. 11 and 11a). Place edge guide and trimmer head above the surface you are going to edge, as shown in Fig. 14. 2.
AUTOMATIC LiNE FEED SYSTEM (Fig. 15 and 16) When turning the trimmer ON for the first time a small length of line will automatically be fed out of the spool. To extend the line out to the full 12-inch cutting path, it will be necessary to start the trimmer and completely stop the trimmer approximately 4 to 5 times. Each time during this operation the line will be extended approx. ¼ to 1/2=inch(See Fig. 15). Continue _ J/_ /_q extending the line until it comes into contact with the _\ //f _.
z:_ CAUTION: cutting Before you begin trimming, only use the appropriate type of | line. BRACKETS FOR CORDLESS TRIMMER, CHARGING STAND AND BATTERY PACK cont. (Figs. 21, 22, 22a and 23) Trimmer mounts two ways OPERATING TIPS 1. Before each use make sure the protective safety guard is tightly installed. Tighten tile guard screw, but DO NOT over tighten. 2. Be sure to check the auxiliary handle before each use, to make sure it is firmly tightened. 3.
Z_ WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other part may create a hazard or cause product damage. Z_ WARNING: To avoid injury, ALWAYS turn trimmer off and disconnect the battery from the trimmer BEFORE installing parts or cleaning the trimmer or making any adjustments. ] i GENERAL MAINTENANCE Keep your trimmer clean and in good repair for maximum long-lasting performance. Check for damaged, missing, or worn parts.
12-in.Weedwacker ®Cordless Trimmer The modelnumberwill be foundon the nameplate of the Trimmer.Always mentionthe model number when requestingparts and servicefor yourtool. ModelNo.172.74815 / "_- 38 39 40 41 \ \ \\ \ 34 19 / / / 20 / 31 12=in.Weedwacker ®Cordless Trimmer Model No. 172.74815 Item No. The modelnumberwill be foundon the nameplate of theTrimmer. Always mentionthe modelnumberwhen requestingparts and servicefor your tool. Parts No. Part Description Qty. Parts No.
Your Home For expert troubleshooting and home solutions advice: www.managemyhome,com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters. 1-800-4-MY-HOME (1-800-469-4663) www.sears.
