Owners manual

13 ― English
OPERATION
WARNING!
Do not allow familiarity with
products to make you careless. Remember
that a careless fraction of a second is
sufcient to inict serious injury.
WARNING!
Always remove battery
pack from your tool when you are assembling
parts, making adjustments, cleaning, carrying,
transporting or when not in use. Removing
battery pack will prevent accidental starting
that could cause serious personal injury.
WARNING!
Always wear eye
protection with side shields marked to comply
with ANSI Z87.1, along with head protection.
Failure to do so could result in objects being
thrown into your eyes and other possible
serious injuries.
WARNING!
Do not use any
attachments or accessories not
recommended by the manufacturer or retailer
of this product. The use of attachments or
accessories not recommended can result in
serious personal injury.
Before each use, inspect the entire product
for damaged, missing, or loose parts such
as screws, nuts, bolts, caps, etc. Tighten
securely all fasteners and caps and do
not operate this product until all missing or
damaged parts are replaced.
APP
LICATION
S
You may use this product for the purposes
listed below:
■ Limbing and pruning branches from trees.
■ Felling small trees up to 9 inch diameter.
■ Bucking the fallen tree into shorter lengths
NOTE:
For complete charging instructions,
refer to the OPERATOR’S MANUAL for your
battery pack and charger.
TO INSTALL / REMOVE BATTERY PACK
See Figure 7, page iii
NOTE:
To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the safety switch when
carrying or transporting the tool.
TO INSTALL:
■ Align the tongue of the battery pack with
the cavity in the chainsaw.
■ Grasp the chainsaw rmly.
■ Push the battery pack into the chainsaw
until the latch locks into place.
■ Do not use force when inserting the battery
pack. It should slide into position and “click”.
TO REMOVE:
■ Press the release button on the battery
pack to release the battery pack from the
chainsaw.
■ Grasp the chainsaw rmly, and pull the
battery pack out.
CHAIN OIL SYSTEM
See Figure 8, page iii
Check and ll the oil tank when battery is
recharged, or as needed.
CAUTION:
Remove battery pack from unit
before checking and lling oil reservoir. Fill oil
tank with Craftsman Bar and Chain Oil before
starting the chainsaw. Failure to lubricate
the chain will cause damage to the bar and
chain.
NOTE:
BAR & CHAIN OIL NOT INCLUDED.
BAR & CHAIN OIL MUST BE ADDED PRIOR
TO USE.
■ Use standard Craftsman chainsaw bar and
chain oil. It is designed for chains and chain
oilers, and is formulated to perform over
a wide temperature range with no dilution
required.