Owners manual
19 ― English
CARE AND MAINTENANCE
WARNING!
When servicing, use only
identical replacement parts. Use of any other
parts may create a hazard or cause product
damage.
WARNING!
Always wear eye
protection with side shields marked to
comply with ANSI Z87.1, along with hearing
protection. Failure to do so could result in
objects being thrown into your eyes resulting
in possible serious injuries. If operation is
dusty, also wear breathing protection.
WARNING!
To avoid serious personal
injury, always remove the battery pack from
the tool when cleaning or performing any
maintenance.
WARNING!
Do not at any time let
brake uids, gasoline, petroleum-based
products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which
may result in serious personal injury.
Remove the scabbard when user is
performing any maintenance or cleaning.
Always place scabbard over the bar when
chainsaw is not in use.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil,
grease, etc.
BATTERY PACK
■ Store the battery pack fully charged.
■ Recharge the battery pack whenever
there is a noticeable reduction in chainsaw
performance. Do not allow the battery pack to
become completely discharged.
■ Do not recharge a battery pack that is
already fully charged. Overcharging shortens
battery life.
■ Once the battery pack is fully charged,
remove the battery from the charger and
disconnect the charger from the outlet.
■ Do not store the battery pack on the tool or
in the charger.
■ Recharge the battery at a temperature
between 23
o
F and 122
o
F. If the battery pack
is hot, allow it to cool down before recharging.
CHARGER MAINTENANCE
■ Keep the charger clean and clear of debris.
Do not allow foreign material to get into the
recessed cavity or onto the contacts. Wipe
the charger clean with a dry cloth. Do not
use solvents or water, and do not place the
charger in wet conditions.
■ Unplug the charger when there is no
battery pack in it.
■ Keep the charger stored in normal room
temperature. Do not store it in excessive
heat. Do not use in direct sunlight.
LUBRICATION
All of the motor bearings in this product are
lubricated with a sufcient amount of high-
grade oil for the life of the unit under normal
operating conditions. Therefore, no further
lubrication is required.
CHAINSAW CARE
Switch the chainsaw off, remove the battery
pack and let it cool down.
Check, clean and store the chainsaw as
described below.
Keep the chainsaw clean. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the chainsaw.
Inspect the chainsaw before each use for
worn and damaged parts.
Do not operate chainsaw if you nd broken
and worn parts.