Instruction Manual

4
MM
AACC
E
C
D
BB
MM(4)
*Note: Part E is symmetrical and can be used on either side.
STEP 3:
• Install (4) MM in flanges of C and D.
• Wrench tighten fasteners from step 1.
Fasteners
from step 1
• Remove and reuse the top and bottom fasteners from the
top back of the workbench.
• Attach (2) A to workbench, as shown, using existing
hardware (8) AA, (8) BB and (8) CC.
• Finger tighten.
Existing Hardware
A
AA
CC
BB
Flange
pointed back
AA(8)
BB(8)
CC(8)
WARNING: Backwall with Metal Pegboard is only to be attached to
one of the following Workbenches: 14929, 14928, 14925 and
14940.
TOP REMOVAL:
• Remove and reuse fasteners from wood top.
• Remove top from workbench base.
STEP 1:
STEP 2:
• Attach (1) C and (1) D to (2) E and (2) A, as shown, using (8)
AA, (8) BB and (8) CC.
• Finger tighten.
ASSEMBLY