Owner`s manual

AC / DC CURRENT MEASUREMENTS

CAUTION: Do not make current measurements at 10 Amps

for longer than 30 seconds. Exceeding 30 seconds may cause

damage to the meter and/or the test leads.

1. Insert the black test lead banana plug into the negative COM

jack.

2. For current measurements up to 200mA AC or DC, set the

function switch to the 200m AAC or ADC position and insert

the red test lead banana plug into the mA jack.

3. For current measurements up to 10A AC or DC, set the

function switch to the 10A AAC or 10A ADC position and

insert the red test lead banana plug into the 10A jack.

4. Remove power from the circuit under test, then open up the

circuit at the point where you wish to measure current.

5. Touch the black test probe tip to the negative side of the

circuit. Touch the red test probe tip to the positive side of the

circuit.

6. Apply power to the circuit.

7. Read the current in the display.