Owner`s manual

DC VOLTAGE MEASUREMENTS

CAUTION: Do not measure DC voltages if a motor on the circuit

is being switched ON or OFF. Large voltage surges may occur

that can damage the meter.

1. Set the function switch to the

highest VDC position.

2. Insert the black test lead

banana plug into the negative

COM jack.

Insert the red test lead

banana plug into the positive

V jack.

3. Touch the black test probe tip

to the negative side of the

circuit. Touch the red test

probe tip to the positive side

of the circuit.

4. Read the voltage in the

display. Move the function

switch to successively lower

VDC positions to obtain a ÷

higher resolution reading. "_ I' I' _0