Owner`s manual

BATTERY REPLACEMENT

WARNING: To avoid electric shock, disconnect the test leads

from any source of voltage before removing the battery cover.

1. When the battery becomes exhausted or drops below the

operating voltage, “ ” will appear in the left-hand side of the

LCD display. The battery should be replaced.

2. See the Battery Installation section of this manual.

3. Dispose of the old battery properly.

WARNING: To avoid electric shock, do not operate your meter

until the battery cover is in place and fastened securely.

NOTE: If your meter does not work properly, check the fuses and

battery to make sure that they are still good and that they are

properly inserted.

FUSE REPLACEMENT

WARNING: To avoid electric shock, disconnect the test leads

from any source of voltage before replacing the fuses.

1. Disconnect the test leads from the meter.

2. Remove the protective rubber holster.

3. Remove the battery cover (two “B” screws)

4. Disconnect and remove the battery.

5. Remove the four “A” screws securing the rear cover.