Owner`s manual

RELATIVE

The relative measurement feature allows you to make measurements

relative to a stored reference value. A reference voltage, current, etc. can

be stored and measurements made in comparison to that value. The

displayed value is the difference between the reference value and the

measured value.

1. Perform any measurement as described in the operating instructions.

2. Press the RELATIVE button to store the reading in the display and the

"REL" indicator will appear on the display.

3. The display will now indicate the difference between the stored value

and the measured value.

4. Press the RELATIVE button to return to normal operation.

DC VOLTAGE MEASUREMENTS

CAUTION: Do not measure DC voltages if a motor on the circuit is

being switched ON or OFF. Large voltage surges may occur that can

damage the meter.

1. Set the function switch to the V DC position (“mV” will

appear in the display).

2. Insert the black test lead banana plug into the negative

(COM) jack and the red test lead banana plug into the

positive (V) jack.

3. Touch the test probe tips to the circuit under test. Be

sure to observe the correct polarity (red lead to

positive, black lead to negative).

4. Read the voltage in the display. The display will

indicate the proper decimal point and value. If the

polarity is reversed, the display will show (-) minus before the value.