Owner`s manual

Theoperationofanytillercanresultinforeignobjectsthrownintotheeyes,whichcan
resultinsevereeyedamage.Alwayswearsafetyglassesoreyeshieldsbeforestarting
your tiller and while tilling We recommend wide vision safety mask for over the
spectacles or standard safety glasses°
HOW TO USE YOUR TnLLER
STOPPING (See Fig. 4)
TINES
o Raise Tiller to transport position.
o Pull forward on tine clutch lever.
ENGINE
• Move throttle control to "STOP" position.
o Never use choke to stop engine
ATTACHING TILLER TO TRACTOR
(See Fig. 5)
o Rear wheel weights and tire chains can be used if
additional traction is required for tilling.
o Place Tiller' on ground level and back up tractor to it
for assembly
• Slide Floating Hitch of Tiller over the tractor drawbar
so that the hitch pin holes line up
• Insert hitch pin until it extends from the bottom of the
Floating hitch_ Insert hair cotter pin into hitch pin.
HITCH PII_
TRACTOR
DRAWBAR
HAIR COTTER PIN
TRANSPORTSNG YOUR TILLER
AROUND THE YARD
o Pull forward on lift handle until it locks in the up
transport posttton.
AROUND TOWN
_' Disconnect spark plug wire,
a Drain fuel tank,
o Transport in the upright position to prevent oil leakage.
"1
CAUTION: Before lifting or trans- |
porting, allow tiller engine and
1
muffler to cool. Disconnect spark
plug wire. Drain gasoline from fuel
tank.,
STARTING TO TiLL
o Raise Tiller to transport position,_
• Start Tiller engine and move throttle control to full
speed.
o Push rearward on tine clutch lever to start tine
rotation_
o Move Tiller lift handle to lower Tiller.
o Setect lowest tractor ground speed at tractor engine
idle.
TO ADJUST DEPTH STAKE
o Depth stake has five position holes to select tilling
depth from 1 to 5 tnches_
• The top stake hole selects the sallowest tilling depth
and the bottom stake hole selects the deepest position.
a To change depth remove the hair cotter pin from the
clevis pin which is connecting the depth stake to the
stake support bracket..
o Grasp the top of the depth stake, remove the clevis pin
and reposition the drag stake_ Insert clevis pin and
hair cotter pin_
IMPORTANT: THE DRAG STAKE SHOULD NEVER BE
REMOVED FROM THE TILLER IT IS DESIGNED TO
PROTECT THE TRACTOR TRANSAXLE FROM THRUSTING
ACTION OF THE TILLER°
RG. 5
8