Owner`s manual

WIRING ASSEMBLY (See Figs. 13 thru 18)

I _ CAUTION:Beforeworking onelectrical

system, disconnect battery. Reconnect

battery when finished.

1. Locate the black plastic hole plug in upper right or left

corner of dash. Remove plug from dash and discard.

NOTE: Some dashes do not have a hole and plug for the

lift switch. These are plastic dashes that can be identified

by a magnet mounted on top of the dash which holds the

hood in place. Using the template provided on page 11

of this manual, drill a 1/2" dia. hole in the dash for

mounting the lift switch (See Fig. 13B).

2. Install one face nut on lift switch and tighten

securely.

3. Insert lift switch into dash hole (with Keyway down)

from underside of dash. Install flat washer, intemal

tooth Iockwasher and remaining face nut onto lift

switch and tighten nut securely.

4. Connect ground wire (black single wire) to lift switch.

a. Viewing lift switch from under hood, connect

black wire to upper left hand side terminal of

switch.

b. Connect opposite end (eyelet) under the right or

left upper rear battery support nut. The support

nut is located on the inside of the side panel.

HOLE PLUG

PLASTIC DASH WITHOUT HOLE AND PLUG

DRILL 1/2 IN. DIA. HOLE

USING TEMPLATE

PROVIDED ON PAGE 13

FIG, 13B

LIFT

SW,TCN

SLACK

Cw , ODNO ILJ,I '..-',r'u

FIG. 14

UPPER REAR SUPPORT

BOLT AND NUT - USE

EITHER RIGHT OR LEFT

SiDE FOR GROUNDING

SIDE

PANEL

FIG. 13A

FIG. 15