Owner`s manual

PRE-ASSEMBLE FRAME BRACKET, PIVOT
TUBE AND ACTUATOR (See Fig. 4)
1. Position pivottube on actuator hub, align holes and
insert 2-1/2 in. long pivot pin and secure with retainer
spring•
2. Position pivottube in frame bracket, align holes and
insert 2-1/2 in. long pivot pin and secure with retainer
spring.
RETAINER PIVOT TUBE
SPRINGS
PIVOT PINS
2-1/2 IN,
ACTUATOR
FRAME BRACKET
ASSEMBLY
FIG. 4
ASSEMBLE FRAME BRACKET AND
ACTUATOR TO TRACTOR (See Figs. 5-7)
1. Through opening above the rear drawbar, slide
frame bracket and actuator assembly into position
between side rails of frame and align mounting
holes.
2. On R.H. frame rail install two (2) 5/16-18 x 1 hex
bolts, in direction shown, and Iocknuts. Do not
tighten•
3. On L.H. frame rail install two (2) 3/8-16 x 1 hex bolts,
in direction shown, and Iocknuts.
4. Tighten all four bolts and nuts securely.
L.H. FRAME FRAME BRACKET
RAIL AND ACTUATOR
ASSEMBLY
R.H. FRAME
RAIL
3/8
LOCKNUTS
3/8-16 X 1 ,
HEX BOLTS
5/16-18 X 1
HEX BOLTS
5/16
LOCt_Rn's
FIG. 7
FRAME
BRACKETAND
ACTUATOR
DRAWSAR
Slide left side
in first
FIG. 5
ASSEMBLE PIVOT ROD BRACKET TO
TRACTOR FRAME (See Fig. 8)
1. Install pivot rod bracket to inside of R.H. frame rail
usingtwo hex bolts 3/8-16 x 7/8 and two 3/8-16
Iocknuts.
2. Tighten hardware securely.
FIG. 8
FIG. 6 7