Owner`s manual

REMOVE HEIGHT INDICATOR (If equipped)
(See Fig. 9)
1. Remove height indicator (ifso equipped) on LH side
of tractorframe. Save all parts except hex bolt for
reassembly.
NYLINER PIVOT ARM
LARGER
PIVOT PIN
NYLINER
LIFT LINKS
HEIGHT
INDICATOR FLAT
(IF EQUIPPED) WASHER
/
LOCK
WASHER
HEX BOLT
FLAT
SNAP-OUT WASHER
COVER
FIG. 9
PRE-ASSEMBLE PIVOT ARM ASSEMBLY
(See Fig. 10A)
1. Assemble both lift links between sides of pivot arm
as shown. Secure with larger pivot pin and retainer
spring•
NOTE: Slots in lift links are not centered and must be
assembled correctly (see figure below). To assemble
hold pivot arm with bent end towards you and down-
wards. Position lift links so slot is to left and narrow edge
is at bottom (see inset).
2. Place spacer between the two links and insert
smaller pivot pin. Secure with retainer spring.
3. Install two nyliners into pivot bracket as shown.
ATTACH ACTUATOR TO PIVOT ARM
ASSEMBLY (See Fig. 10B)
1. Position pivot arm assembly under tractor in front of
actuator.
2. Insert actuator arm and bushing between pivot arms
as shown. Secure with 3/8-16 x 3-1/4 hex bolt and
Iocknut.
NOTE: Bolt must be assembled in direction shown.
SMALLER ""
PIVOT PIN
SPACER
.ETA,NER/--
SPRINGS
BE SURE SLOT IS
TO LEFT AND
NARROW EDGE IS
TO BO'I-fOM
BENT END OF
PIVOT ARM
HEX BOLT
3J8-16 X 3-1/4
ACTUATOR
FIG. 10A
INSET
BUSHING
LOCKNUT
3/8-16
8 FIG. 10B