Owner`s manual

INSTALL PIVOT ARM ASSEMBLY TO
TRACTOR (See Figs. 11A & 11B)
1. Slide 21/32 x 1 x 21 Ga. washer onto pivot rod
support up to nibs.
NISS
A'n'ACH LIFT LINKS TO LIFT SHAFT
BRACKET(See Fig. 12)
1. Position one lift link on each side of the lift shaft
bracket as shown. Insert smaller pivot pin and
secure with retainer spring.
21/32 X 1 X 21 GA.
WASHER
PIVOT ROD
SUPPORT
FIG. 11A
2. Insert pivot rod support with washer through nyliners
in pivot arm, as shown. Raise entire assembly until
nyliners are in line with hole in LH side of tractor
frame. Loosely assembly hex bolt 3/8-16 x 7/8 and
lock washer through hole in LH side of frame. Do
not tighten at this time.
3. Assemble flattened end of pivot rod support to
underside of pivot rod bracket using hex bolt 3/8-16
x 1-1/4, flat washer and Iocknut and tighten securely.
4. Now tighten previously assembled 3/8-16 x 718 hex
bolt on LH side of frame.
3/8-16 X 7/8
HEX BOLT
NYLINERS AND
PIVOT ARM
LOCK FLAT
WASHER 3/8-16 X 1-1/4 WASHER
HEX BOLT
RETAINER
SPRING
\
LIFT LIFT LINK
SHAFT (One on each side of
BRACKET lift shaft bracket)
SMALLER
PIVOT PIN
FIG. 12
ACTUATOR
LOCKNUT
HOLEIN LH _DE PIVOT ROD
OFTRACTOR PIVOT ROD BRACKET
FRAME SUPPORT
FIG. 11B
9