Owner`s manual

ASSEMBLY
i
CONNECT BA't-I'ERY (See Fig. 2)
CAUTION: Do not short battery termi-
nals. Before connecting battery, re-
move metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
o Lift hood to raised "position,.
o Open terminal access doors, remove terminal protec-
tive caps and discard,,
o if this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amp&
• First connect RED battery cable to positive (+) battery
terminal with hex bolt, flat washer, lock washer and hex
nut as shown. Tighten securely.
o Connect BLACK grounding cable to negative (-) bat-
tery terminal with remaining hex bolt, fiat washer, lock
washer and hex nut. Tighten securely.
o Ciose terminal access doors..
Use terminal access doors for:
* Inspection for secure connections (to tighten hard-
ware).
. Inspection for corrosion
= Testing battery.
o Jumping (if required)°
Periodic charging.
LOCK FLAT
HEX NUT WASHER WASHER
D'SCARD TERMINAL X _ HEX
PROTECTIVE CAPSII_ \ _, _ BOLT
ACCESS _ ....,:_z"_._:
DOOR POSmVE
..... .____E
_i '_ -- CABLE
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob,
o Remove cardboard packing on seat pan,,
o Place seat on seat pan and assemble shoulder bolto
= Assemble adjustment knob and ftat washer loosely.
Do not tighten.
° Tighten shoulder bolt securely,
o Lower seat into operating position and sit on seat.
= Slide seat until a comfortable position is reached which
aIIows you to press clutch/brake pedal all the way
down.
= Get off seat without moving its adjusted position.
o Raise seat and tighten adjustment knob securely.
SEAT
SHOULDER \, '_\\_ \' \\ \
BOLT_. _ __-- \ \\ \V-___ \ \ ', \\ \
/_' FLAT WASHER
ADJUSTMENT
KNOB
FIG. 3
TO A'n'ACH NOSE ROLLER (See Fig. 4)
= Position brackets, 17/32 x7/8 x t6 gauge washers, and
nose roller between deck mounting brackets as shown.
Be sure to position brackets on correct side, as showm
= install 3/8-16 x 1 hex bolts and 3/8-16 crownlock nuts
as shown Tighten hardware securety_
NOTE: Be sure bracket tabs are positioned in tab holes in
deck brackets.
"B"BRACKETTAB
HEX
BOLT
"A" CROWNLOCK
NUT
TAB WASHER
FIG, 4
8