--w. i lull l i,,,,it,lllll,,i OWNER'S MANUAL MODEL NO. 917.255575 ® 12,5 HP _C ELECTRIC START 3 6n One Convertible 38" MOWER DECK 6 SPEED TRANSAXLIE LAWN TRACTOR Caution: Read and follow all Safety Rules and Instructions Before Operating This Equipment oAssembiy ° Operation o Customer Responsibilities o Service and Adjustment o Repair Parts Sears, = u nmH,,,,,u Roebuck i nnH,H, and Co., Hoffman , UHI,, Estates, 'H, IL 60179 U.S.A. I ,,',,,',', ..........................................
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEETANDTHROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT iN SERIOUS INJURY OR DEATH.
PRODUCT CONGRATULATIONS on your purchase of a Sears tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.
TABLE OF CONTENTS SAFETY RULES ............................................................ 2 PRODUCT SPECIFICATIONS ....................................... 3 CUSTOMER RESPONSIBILITIES ..................... 3, 15-18 WARRANTY ................................................................... 3 TABLE OF CONTENTS ................................................. 4 INDEX ........................... ;................................................. 4 TRACTOR ACCESSORIES ........................................
i,ii illlllll ii ii iJi lulll, ACCESSORIES ............................ i, lUll, AND iii ii ATTAC ................ i i l i,, iiill ENTS , ............... These accessories and attachments were available when the tractor was purchased, They are also available at most Sears retail outlets, catalog and service centers.
CONTENTS OF HARDWARE PACK ................ , ..... ............... i i , ],,,i mlnlll H. Parts Bag contents ........................ H ,H " , shown m, i ,, i ................................ full size i n,,.uu ,unH ,i. ii Parts packed i separately ............................ in carton ,mu H.
ASSSM L¥ i i 1,1,11 ii ii, iiii Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes, To ensure safe and proper operation of your tractor, al_parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure their proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard wrench sizes are listed.
ASSEMBLY 1,1,111 HOW TO SET UP YOUR PREPARE BATTERY .................. iii Adjust seat before tightening adjustment bolt. (See Fig. 2) . Place seat on pan and assemble shoulder bolt. Wash hands or clothlng Immediately If accidentally in contact with battery acid. • Assemble adjustment bolt, lock washer and flat washer loosely. Do not tighten= Do not smoke. Fumes from charged battery acid are explosive. Read the instructions included with the batteryventcaps.
ASSEMBLY INSTALL BATTERY (See Figs. 4 & 5) BATTERY BOX DOOR CAUTION: Do not short battery terminals. Before installing battery, remove A i rings, etc. etal bracelets, wristwatch bands, Positive terminal must be connected first to prevent sparking from accidental grounding. ii ,i, ,,i1,11, POSITIVE (RED) "_" CABLE i ,,,111 • Lift seat to raised position. • Open battery box door, • Lower battery into battery box with battery terminals toward front of tractor.
i, ,i,i i,i, i, i1,, i ii1,,-,,,,,,,,, H,II,, ii ASSEMBLY ' INSTALL ,11,, i,i.......... IViULCHER iii i1,1 ,i,i1,,,,,i,,,i,, PLATE ,i i,ii ii TO CONVERT TO BAGGING (See Figs. 6 & 7) O Assemble flat washer, lock washer and wing nut to mounting bolt and tighten securely.
OPEF ATIO .... ,, ,,,,,,,,,,,,,, ,,,,, KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourselfwith the locations of various controls and adjustments. Save this manual for future reference. A'I'FACNM ENT CLUTCH LEVER IGNITION SWITCH LiFT LEVER PLUNGER ATTACHMENT LIFT LEVER LIGHT SWITCH THROTTL_CHOKE CLUTCH/BRAKE MOWER DECK HEIGHT ADJUSTMENT POSITIONS PARKING GEARSHIFT LEVER FIG.
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend wide vision safety mask for over the spectacles or standard safety glasses, available at Sears Retail or Catalog stores.
OPERATION TO OPERATE MOWER (See Fig, 10) • Yourtractorisequippedwithanoperatorpresencesensing switch, Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine • Select desired height of cut • Engage mower by slowly moving attachment clutch lever to "ENGAGED" position_ TO STOP MOWER- Move attachment clutch lever to "DISENGAGED" position, • .
__ ,=, ,,= ,n ,==,=== in=n!n.n ................. OPERATION = 1,1! 1,1 ,11,1,11, , ==,,i......................................... TO START ENGINE (See Fig. 9) • When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc, After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig.
MAINTENANCE SCHEDULE AS YOUCOMPLETE REGULAR SERVICE /__/S_ _O_, __ERVICE Check Brake Operation 6# 4 Check Tire Pressure V" T Check for Loose Fasteners V" AR Sharpen/Replace Mower _ Battery LeveltRecharge 0 Clean Battery and Terminals R 'Check Transmission Blade Adjust Morton Drive Belt(s) Check Engine Oil Level Change E N Clean Belt(s) Engine inspect I Replace DATES v" v, M_ MY" V" Tension "_i #'- Oil Air Filter :: Muffler/Spark Oil Filter I_ Arrester (if
i CUSTOMER , i u ....... RESPONSIBILmES TRACTOR Always observe nance, ii TO SHARPEN BLADE (See Fig. 15) safety rutes when performing Care should be taken to keep the biade balanced. An unbalanced blade wilt cause excessive vibration and eventual damage to mower and engine. any mainte- BRAKE OPERATION If unit requires more than six (6) feet stopping distance at high speed in highest gear, than brake must be adjusted.
CUSTO ILITmES RESPON TO CLEAN BATTERY AND TERMINALS _ Corrosion and dirt on the battery and terminals can cause the battery to "leak" power. • Remove terminal guard. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor, • Wash battery with solution of four tablespoons of baking sodato one gallon of water, Be careful notto get the soda solution into the ceils. • After oil has drained completely, replace oil drain plug and tighten securely.
.................................. iinulu u=uHuml"Hi ..................................... CUSTOMER RESPON TO SERVICE CARTRIDGE • Remove knob and cover plate, BmL ES , Install replacement oil fitter by turning clockwise untii rubber gasket contacts mounting surface, then tighten filter an additional 1/2 to 3/4 turn. • Remove cartridge and clean by tapping gently on flat surface. . . If very dirty, replace or wash in a nonsudsing detergent and warm water solution.
SERVmCE AND ADJUSTMENTS CAUTION: o BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever In "NEUTRAL" position. Place attachment clutch In "DISENGAGED" position, Turn Ignition key "OFF" and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where It cannot come In contact with plug. iiii1,1,,,11,,111111,111 .................................
SERVnCE AND ADJUSTMENTS J, ,uu,u ........................................................................................................ TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCTSPEClF1CATIONS"on page3ofthis manual).
,r,,,,1=,1 SERVICE AN .... TO REPLACE (See Fig. 25) i MOWER ..... ii, ADJUSTMENTS ,,,,i,1,1111 ,,, BLADE DRIVE BELT WITH PARKINGBRAKE"ENGAGED" The mower blade drive belt may be replaced without tools, Park the tractor on level surface, Engage parking brake. For assistance, there is a belt installation guide decal on the mower housing. BELT REMOVAL • Place attachment clutch in "DISENGAGED" position, • Move attachment lift lever forward to lower mower to its lowest position.
I"IHII'H'I'IHI' '1'"' "11 "1 I ' ' I SERVICE AN ADJUSTMENTS I ..................................... TO ADJUST STEERING WHEEL ALIGNMENT TO START ENGINE See Fig.
=== SERVICE AND ADJUSTMENTS ii TO REPLACE FUSE (See Fig. 30) TO REMOVE HOOD • Raise hood, Replace with 30 amp automotive.type piug4n fuse. The fuse holder is located in the engine compartment, directly in front of the dash AND GRILL (See Fig. 31) • Unsnap headlight wire connector. • Stand in front of tractor, Grasp hood at sides, tilt forward and lift off of tractor. • To reinstall_ slide hood pivot brackets into slots in frame.
i ,ll ..... i = = i i,,i,ill,,i .... i ,,=l ,,l= .................... ill,, SSRWCE AND ADJUSTMENTS = = H=HHHI, ,,,q=,,, ENGINE TO ADJUST THROTTLE (See Fig. 32) FINAL SETTING - CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows: * With engine no! running_,move throttle control lever from "SLOW" to 'CHOKE position.
Immediately prepare your tractor for storage at the end of the season or ifthe unit will not be used for 30 days or more. CAUTION: ENGINE FUEL SYSTEM IMPORTANT: IT tS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER. FUEL HOSE, OR TANK DURING STORAGE, ALSO. EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE.
i. ,111.... i1,11111.11..11.., i , . i . i TROUBLESHOOTING PROBLEM CAUSE Wiltnet start ! Out of fuel. 2 3 4 5. 6 7. Engine not "CHOKED" Engine flooded_ Bad spark plug Dirty air fitter. Dirty fuel filter Water in fuel POINTS CORRECTION i, 2 3, 4_ 5 6 7, properly. Fillfuel tank. See "TO START ENGINE" in Operation section_ Wait several minutes before attempting to start. Replace sparkplug. Clean/replaceair filter, Replace fuelfilter.
IH,I, i i,,11 TROU PROBLEM i ............... LESHOOTING POINTS CAUSE .............. CORRECTION ,.,,,,, ,, ,, Engine continues to run when operator leaves seat with attachment clutch 1. ....................... ,,,,,,,,,,, Faulty operator.safety presence control system. Check wiring, switches and connections, tf not corrected, contact See_ Service Center/Department engaged .... i, Poor cut • uneven .
12.5 HP 38" TRACTOR - - MODEL NUMBER 917.255575 SCH EIViATIC RED BLACK BATTERY RED RED WHITE , "Jill"-" t I I STARTER BLACK iv It1 ..... v_ J SOLENOID BLACK SEAT SWITCH IGNITION SWITCH I I........ t .......
